Skip to search formSkip to main content
You are currently offline. Some features of the site may not work correctly.

Current injection technique

The current injection technique is a technique developed to reduce the turn-OFF switching transient of power bipolar semiconductor devices. It was… Expand
Wikipedia

Papers overview

Semantic Scholar uses AI to extract papers important to this topic.
2018
2018
This paper highlights the power quality issues and explains the remedial measures taken by means of hybrid front-end third… Expand
  • figure 1
  • figure 2
  • table I
  • figure 3
  • figure 4
2016
2016
Abstract Power flow analysis of distribution networks incorporating LV consumer representation needs to be cognizant of an… Expand
2010
2010
Smart grids offer a new application domain for power electronics. In fact, every Distributed Energy Resource (DER) includes an… Expand
  • figure 1
  • figure 2
  • figure 4
  • figure 5
  • figure 3
2010
2010
This paper proposes a new three-phase power factor correction rectifier using current injection technique. This topology uses two… Expand
  • figure 1
  • table I
  • figure 3
  • figure 5
  • figure 7
2009
2009
  • B. Zhang, U. Jiang
  • 3rd IEEE International Symposium on Microwave…
  • 2009
  • Corpus ID: 23280037
The direct current injection (DCI) technique is being widely researched for its application in aircraft EMC test as an… Expand
  • figure 1
2008
2008
In this paper, a practical current injection based built-in test (BIT) technique for impedance-matched RF low-noise amplifiers… Expand
  • figure 2
  • figure 1
  • figure 3
  • figure 4
  • figure 5
2008
2008
  • S. Eio, N. Shammas
  • 43rd International Universities Power Engineering…
  • 2008
  • Corpus ID: 6707987
In this paper, experiments where current was injected into an IGBT (insulated gated bipolar transistor) during its turn-off… Expand
  • figure 2
  • figure 1
  • figure 3
  • figure 4
  • figure 5
2001
2001
It is shown that third harmonic current injection can produce higher shaft torque than conventional sinusoidal current regulation… Expand
  • figure 1
  • figure 2
  • figure 4
  • figure 7
  • figure 5
Highly Cited
1993
Highly Cited
1993
A simple three-terminal technique for measuring the off-state breakdown voltage of FETs is presented. With the source grounded… Expand
  • figure 1
  • figure 3
1978
1978
The surface current injection technique can provide low cost, in situ EMP testing of aircraft systems. It has not provided… Expand
  • table 1
  • figure 1
  • figure 2
  • figure 3
  • figure 4