Ultimate failure

In mechanical engineering, ultimate failure describes the breaking of a material. In general there are two types of failure: fracture and buckling… (More)
Wikipedia

Topic mentions per year

Topic mentions per year

1978-2016
051019782016

Papers overview

Semantic Scholar uses AI to extract papers important to this topic.
2016
2016
The ageing effect of glass/epoxy composite laminates exposed to seawater environment for different periods of time was… (More)
Is this relevant?
2015
2015
  • Xin Yanga, Qiang Xub, Zhongyu Luc
  • 2015
This paper reports research on the study of the relative significance of various internal creep damage mechanisms on the overall… (More)
  • table 2
  • table 3
Is this relevant?
2012
2012
While hydrogen embrittlement of ferritic steels has been a subject of significant research, one of the major challenges in… (More)
  • figure 1
  • figure 2
  • figure 3
  • figure 4
  • figure 5
Is this relevant?
2011
2011
The behaviour of deep beams is significantly different from shallow beams. In deep beams, the plane section does not remain plane… (More)
  • table 1
  • table 2
  • figure 1
  • figure 2
  • figure 3
Is this relevant?
2010
2010
The development cycle of new products can be dramatically reduced if exact lifetime models are at hand. This requires the precise… (More)
  • figure 1
  • figure 2
  • figure 3
  • figure 5
  • figure 4
Is this relevant?
2007
2007
Outright bank failures without prior indication of nancial instability are very rare. Supervisory authorities monitor banks… (More)
  • table 1
  • table 2
  • table 4
  • table 5
  • figure 1
Is this relevant?
2006
2006
This paper explores the use of artificial neural networks in predicting the failure load of castellated beams. 47 experimental… (More)
  • figure 1
  • figure 2
  • figure 3
  • figure 4
  • figure 5
Is this relevant?
2005
2005
The failure modes of flip chip solder joints under high electrical current density are studied experimentally. Three different… (More)
  • table 1
  • figure 3
  • figure 1
  • figure 2
  • figure 4
Is this relevant?
2005
2005
INTRODUCTION Shoulder separations are common injuries. Controversy exists over the optimal treatment. More importantly, no single… (More)
Is this relevant?
2004
2004
Brittle failures in mechanical timber joints should be avoided, because this often results in low capacity and brittle failure of… (More)
  • figure 2
  • figure 1
  • figure 3
  • table 1
  • figure 4
Is this relevant?