Skip to search formSkip to main contentSkip to account menu

K–omega turbulence model

Known as: K-omega turbulence model, K-ω turbulence model, K–ω turbulence model 
In computational fluid dynamics, the k–omega (k–ω) turbulence model is a common two-equation turbulence model, that is used as a closure for the… 
Wikipedia (opens in a new tab)

Papers overview

Semantic Scholar uses AI to extract papers important to this topic.
2014
2014
Wind load is one of the significant factor for design of greenhouse structure. Among related factors to wind load, wind pressure… 
2014
2014
The choice of materials for rocket chamber walls is limited by its thermal resistance. The thermal loads can be reduced… 
2012
2012
This paper aims at researching the shape coefficient of tall buildings with the different height and width by comparing some… 
2008
2008
This thesis compares previously published heat transfer measurements from a pre-swirl rotor-stator experiment with 3D steady… 
2004
2004
Two aspects of turbulence modelling were addressed with respect to a single cylinder in crossflow. Firstly, the effect of varying… 
2000
2000
Steam-carrying superheater and reheater tubes in fossil-fired boilers operating at temperatures above 900F (482C) are subject to… 
1995
1995
The suitability of a Babcock & Wilcox cyclone furnace to vitrify a low-level radioactive liquid waste was evaluated. The feed… 
1986
1986
The continuous or intermittent use of natural gas in place of oil or coal in existing utility boilers would reduce emissions of… 
1967
1967
Polge (1955) stored fowl semen in a glucose-citrate solution with either milk or thin egg albumen. Promising fertility results… 
1957
1957
Initial scope drawings and descriptions for the Babcock and Wilcox nuclear merchant ship reactor (NMSR) control rod drive system…