XPS study of basic aluminum sulphate and basic aluminium nitrate

@article{Duong2005XPSSO,
  title={XPS study of basic aluminum sulphate and basic aluminium nitrate},
  author={Loc V. Duong and Barry J. Wood and J. Theo Kloprogge},
  journal={Materials Letters},
  year={2005},
  volume={59},
  pages={1932-1936}
}
Basic aluminium sulphate and nitrate crystals were prepared by forced hydrolysis of aluminium salt solution followed by precipitation with a sulphate solution or by evaporation for the basic aluminium nitrate. X-ray Photoelectron Spectroscopy (XPS) confirms the chemical composition determined by ICP-AES in earlier work. High resolution XPS scans of the individual elements allow the identification of both the central IVAlO4 group and the 12 aluminium octahedra in the [IVAlO4AlVI(OH)24(H2O)12… Expand
Influence of aluminium precursor on physico-chemical properties of aluminium hydroxides and oxides
The paper concerns aluminium hydroxides precipitated during hydrolysis of aluminium acetate in ammonia medium, as well as aluminium oxides obtained through their calcination at 550, 900 or 1200°C forExpand
Influence of aluminium precursor on physico-chemical properties of aluminium hydroxides and oxides
AbstractAn attempt to obtain aluminium hydroxide that could give aluminium oxides of increased thermal stability was made. Aluminium hydroxide was precipitated during a hydrolysis of aluminiumExpand
Al-pillared montmorillonite obtained in concentrated media. Effect of the anions (nitrate, sulfate and chloride) associated with the Al species
Basic Al chloride, sulfate and nitrate were prepared by hydrolysis of Al chloride followed by precipitation with a Na sulfate solution, then re-dissolution in a Ba nitrate solution. The threeExpand
Large-scale synthesis and formation mechanism study of basic aluminium sulfate microcubic crystals.
TLDR
Chemical formation mechanism studies of sulfuric acid with γ-AlOOH were performed using a combined experimental and computational approach and equations to quantitatively describe the relationship between the molar amount of H(+) and the final phase are proposed, which has been confirmed by experimental results. Expand
Effect of Mg as Impurity on the Structure of Mesoporous γ-Al203: Efficiency as Catalytic Support in HDS of DBT
Abstract This work shows the study of two alumina materials synthesized from aluminum sulfate with different purity by hydrolysis-precipitation route. The main difference between the aluminum saltExpand
Tuning residual metal in partially etched carbide-derived carbons for enhanced acid gas adsorption
Abstract An in-depth study on post-synthetic modification of residual metal in carbide-derived carbons (CDCs) from an Al4C3 starting material has been performed. Ambient temperature high humidityExpand
Spectroscopic and DFT investigations on the corrosion inhibition behavior of tris(5-methyl-2-thioxo-1,3,4-thiadiazole)borate on high carbon steel and aluminium in HCl media
The effect of tris(5-methyl-2-thioxo-1,3,4-thiadiazole)borate (HB(mtdaMe)3) on the corrosion of high carbon steel (HCS) and aluminium (Al) in HCl media has been examined by Electrochemical ImpedanceExpand
Interaction of SO2 with Pt Model Supported Catalysts Studied by XPS
Sulfur dioxide that exists in gaseous reaction media as a reagent or impurity can have various effects, both poisoning and promoting, on oxide-supported platinum catalysts. In this work, theExpand
A X-ray photoelectron spectroscopy study of HDTMAB distribution within organoclays.
TLDR
High-resolution XPS spectra show that the modification of clay with surfactants has prominent influences on the binding energies of the atoms in both clays and Surfactants, and nitrogen is the most sensitive to the surfactant distribution within the organoclays. Expand
Amorphous nanosized Al–Ti–Mn trimetal hydrous oxides: synthesis, characterization and enhanced performance in arsenic removal
Arsenite (As(III)) is more toxic and more difficult to remove from water than arsenate (As(V)). There is no simple treatment for direct efficient removal of As(III), and thus pre-oxidation of As(III)Expand
...
1
2
3
4
5
...

References

SHOWING 1-10 OF 14 REFERENCES
An XPS study of ion-induced compositional changes with group II and group IV compounds
Abstract Inert-gas ion bombardment and plasma etching are important processes in the fabrication and micromachining of semiconductor devices. Sequential ion etching and surface analysis is alsoExpand
Near-infrared spectroscopic study of basic aluminum sulfate and nitrate
The tridecameric Al-polymer [AlO4Al12(OH)24(H2O)12]7+ was prepared by forced hydrolysis of Al3+ up to an OH/Al molar ratio of 2.2. Under slow evaporation crystals were formed of Al13-nitrate. UponExpand
The dehydroxylation of basic aluminum sulfate: An infrared emission spectroscopic study
Abstract The tridecameric aluminum polymer [AlO 4 Al 12 (OH) 24 (H 2 O) 12 ] 7+ was prepared by forced hydrolysis of Al 3+ up to an OH/Al molar ratio of 2.2. Upon addition of sulfate, the tridecamerExpand
Raman microscopy study of basic aluminum sulfate
The tridecameric aluminum polymer [AlO4Al12(OH)24(H2O)12]7+ was prepared by forced hydrolysis of Al3+ up to an OH/Al molar ratio of 2.2. Upon addition of sulfate the tridecamer crystallised as theExpand
Thermal stability of basic aluminum sulfate
The tridecameric aluminum polymer [AlO4Al12(OH)24(H2O)12]7+ is prepared by forced hydrolysis of an Al(NO3)3 solution by NaOH up to an OH:Al mol ratio of 2.2. Upon addition of sulfate the tridecamerExpand
Raman microscopy study of basic aluminum sulfate Part II Raman microscopy at 77 K
The tridecameric aluminum polymer [AlO4Al12(OH)24(H2O)12]7+ was prepared by forced hydrolysis of Al3+ up to an OH/Al molar ratio of 2.2. Upon addition of sulfate the tridecamer crystallised as theExpand
Solid catalyst treated with anion: XVIII. Benzoylation of toluene with benzoyl chloride and benzoic anhydride catalysed by solid superacid of sulfate-supported alumina
Abstract A solid superacid catalyst with an acid strength of −16.04≫Ho⩽ −14.52 was obtained by exposing γ-Al2O3 to 2.5 M H2SO4 followed by calcining in air at 550–650°C. The catalyst was active forExpand
Aluminum chlorohydrate I: Structure studies.
TLDR
X-ray diffraction and IR and 27AI-NMR spectroscopy indicate that aluminum chlorohydrate is composed of a central aluminum in a tetrahedral configuration surrounded by 12 aluminum atoms in octahedral configuration, consistent with both the method of synthesis and the proposed mechanism of antiperspirant activity. Expand
Correlation between CdS photoanodic behaviour and electrode chemical modifications: An X-ray photoelectron spectroscopic study
The photosensitivity increase of CdS films as a function of the illumination time, is correlated to chemical changes of the electrode surface, analysed by XPS. It is shown that the formation ofExpand
One- and two-dimensional 27Al MAS-NMR study of basic aluminum sulfate
The quadrupole coupling constants (QCC) and asymmetry parameters (η) of the fourfold and sixfold coordinated Al sites in basic aluminum sulfate have been determined by using the field dependentExpand
...
1
2
...