Transmission characteristics of electric wave-filters

@article{ZobelTransmissionCO,
  title={Transmission characteristics of electric wave-filters},
  author={Otto J. Zobel},
  journal={Bell System Technical Journal},
  volume={3},
  pages={567-620}
}
  • O. J. Zobel
  • Published 1 October 1924
  • Engineering
  • Bell System Technical Journal
The transmission loss characteristic of a transmitting network as a function of frequency is an index of the network's steady-state selective properties. Methods of calculation heretofore employed to determine these characteristics for composite wave-filters are long and tedious. This paper gives a method for such determinations which greatly simplifies and shortens the calculations by the introduction of a system of charts. Account is taken of the effects of both wave-filter dissipation and… 

Mutual inductance in wave filters with an introduction on filter design

Principles of Generalized Dissymmetrical Networks. We shall consider first the impedance and propagation characteristics of certain generalized networks, It can be shown that any passive network

Vector Presentation of Broad Band Wave Filters

The function of a broad-band wave filter of the iterative ladder type in the attenuation band, and outside the attenuation band can be explained very simply when expressed in terms of two

Anomalous Transmission in Filters

  • J. Brainerd
  • Physics
    Proceedings of the Institute of Radio Engineers
  • 1935
It is well known that the terminating impedance plays an important rôle in the action of a filter. Using a terminating impedance which approximates the negative of the usual iterative impedance is

Design and Analysis of Electromagnetic Interference Filters and Shields

Parasitic mutual inductance between the input and o utput loops of a shunt capacitor filter limits the attenuation obtainable at high frequencies. This paper presents compact designs for integrated

A Mechanical Demonstration of the Properties of Wave Filters

The nature of wave motion and amplitude and phase distortion of waves are discussed. Wave filters of different types and important uses of wave filters are defined and discussed, and finally, a

Note on the Determination of the Offset Lines in Doherty Power Amplifiers

This letter shows how to find by inspection, the values of the characteristic impedances and the electrical lengths of the offset lines of the main and auxiliary amplifiers constituting a Doherty

MESFET Distributed Amplifier Design Guidelines

In the paper, the analysis of GaAs MESFET distributed amplifiers and a systematic approach to their design are presented. The analysis focuses on fundamental design considerations and also

Expansion Theorems for Ladder Networks

The well-known expansion theorem of Heaviside applies to circuits whose current-electromotive force relations may be expressed through differential equations, whereas in some networks such as filters

Synthesis of wideband cascaded double-pole crystal lattice filters

A design procedure is given for crystal lattice filters with bandwidths for quartz of approximately 1 to 8% of the centre frequency; the method results in simple formulae in terms of the elements of

From R&D laboratories reduction of the chip area of MMIC distributed amplifiers

This paper presents a principle for reduction of the chip area of MMlC distributed amplifiers. It is based upon analysis of the attenuation on the drain line, and results in partly circular gate and