Corpus ID: 113926195

Tool wear monitoring for milling by tracking cutting force model coefficients

@inproceedings{Cui2008ToolWM,
  title={Tool wear monitoring for milling by tracking cutting force model coefficients},
  author={Yanjun Cui},
  year={2008}
}
  • Yanjun Cui
  • Published 2008
  • Engineering
  • This study establishes a way to monitor tool wear in end milling using a tangential force model coefficient method. An experimental investigation of the characteristics of tangential force model coefficients, KTC and KTE, under different cutting conditions is presented. Experimental results indicate that the coefficients are relatively insensitive to the cutting conditions and quite sensitive to tool wear. Several tool wear experiments were performed on AISI 1018 steel. The tool wear was… CONTINUE READING

    Create an AI-powered research feed to stay up to date with new papers like this posted to ArXiv

    References

    Publications referenced by this paper.
    SHOWING 1-10 OF 26 REFERENCES

    A Low Cost Wireless Tool Tip Vibration Sensor for Milling

    • C. A. Suprock, Fussell, B.K, R. B. Jerard, R. Z. Hassan
    • ASME MSEC 2008,
    • 2008

    CUTTING EDGE PREPARATION AND SURFACE ISSUES", HSS Forum's International Conference « Smart solutions for metal cutting

    • Joel RECH
    • 2005

    Fuzzy estimation of feed-cutting force from current measurement-a case study on intelligent tool wear condition monitoring

    State-of-the-art methods and results in tool condition monitoring: a review," International Journal of Advanced Manufacturing Technology, DOI 10.1007/s00170-004-2038-2

    • A. G. Rehorn, J. Jiangand, P. E. Orban
    • 2004

    Code for Smart Tool vibration Data Analysis function [spec,freqs]=VibrationAnalisis() close all; clear all

    • F APPENDIX
    • 2000