The impact of Akiyama probe in biological application

  title={The impact of Akiyama probe in biological application},
  author={Camtu Suhonen},
Camtu Suhonen Department of Materials Science, Tampere University of Technology, Finland. *Corresponding Author: Camtu Suhonen , Department of Materials Science, Tampere University of Technology, Finland. Email: Citation: Camtu Suhonen (2017). The impact of Akiyama probe in biological application . Int J Nano Med & Eng. 2:2, 5-9. Copyright: © 2017 Camtu Suhonen . This is an open-access article distributed under the terms of the Creative Commons Attribution License… 

Figures from this paper


Local Oxidation of Titanium Using Dynamic-Mode Tuning-Fork Probe with Microfabricated Silicon Cantilever
We present a unique probe that is based on a quartz tuning fork and a microfabricated cantilever. The probe is self-actuating and self-sensing. The cantilever can be tailored to the needs of specific
NanoLaboratory Concept: A Platform Combining Advanced Scanning Probe Microscopy and Non-Scanning Probe Microscopy Methods
The NanoLaboratory concept is described as the technical platform for joining of advanced scanning probe microscopy to the most modern non-scanning probe microscopy methods. Specific examples of how
Wafer- and piece-wise Si tip transfer technologies for applications in scanning probe microscopy
A novel tip transfer technology is proposed for applications in scanning probe microscopy (SPM). The technology is based on the concept of fabricating tips on an independent wafer and transferring
AFM studies of nanoparticle deposition via electrospray ionization
Electrospray ionization was used to deposit CdSe nanoparticles on graphite and InP substrates and it was found that above a critical concentration, the deposition process produced large clumps of particles rather than individual particles.
Evaluation of an Electronic Periodontal Probe Versus a Manual Probe.
The present study showed that the use of a standard manual probe is essential to review conspicuous or unclear measurement values, or when treating deep pockets higher than 7mm.
A Unique Self-Sensing, Self-Actuating AFM Probe at Higher Eigenmodes
Although the signal-to-noise ratio in this environment is not good enough, the 2 nm resolution and 0.09 Hz/nm sensitivity prove that the Akiyama probe can be used at its second eigenmode under FM non-contact mode or low amplitude FM tapping mode, which means that it is easy to change the measuring method from normal tapping to small amplitude tapping or non- contact mode with the same probe and equipment.
Solid phase adsorption of crystal violet lactone on silica nanoparticles to probe mechanochemical surface modification.
The solid phase adsorption of crystal violet lactone (CVL) on five types of Stober silica nanopowders with BET specific surface areas in the range of 50-800 m2/g under dry milling conditions was
Impairment of sarcolemmal permeability in the acute ischemic myocardium--a study with ionic lanthanum probe method.
Results indicate that deposition of La occurs before the appearance of irreversible morphologic alterations in ischemic myocardial cells, and suggest an increased permeability of the sarcolemma for Ca2+ and the development of degradation of plasma membrane integrity.
Searching events in AFM force‐extension curves: A wavelet approach
An algorithm, based on the wavelet scalogram energy, for automatically detecting events in force‐extension AFM force spectroscopy experiments is introduced and is illustrated in a tether analysis experiment by using it for the detection of events in the AFMforcing curves susceptible to being considered tethers.
A new automatic contact point detection algorithm for AFM force curves
A new method for estimating the contact point in AFM force curves, based on a local regression algorithm, is presented that can be easily implemented as a computer algorithm and used for a fully automatic detection of the contact points in the approach force curves on living cells.