The Fabrication and Trial Performance of Injector Driver for CRDI

@inproceedings{Kim2013TheFA,
  title={The Fabrication and Trial Performance of Injector Driver for CRDI},
  author={Sang-Am Kim and Woo-Gyeong Wang and On Kim},
  year={2013}
}
Abstract: In this study, for carrying out the spray and combustion experiment using a Common Rail Direct Injection(CRDI) system, the controller was fabricated to drive a high speed camera, a injector and a laser beam sequentially at a low cost. CB280 module of one-chip micro processer was used for the controller. In order to confirm responsibility and utility of the controller, the current drive performance, the spray behavior and the injection rate were tested and analyzed under various… CONTINUE READING

References

Publications referenced by this paper.
SHOWING 1-7 OF 7 REFERENCES

Effect of multiple injection and injection pressure on the combustion and emission characteristics in a passenger car CRDI diesel engine

H. G. Roh, H. S. Jeon, C. S. Lee
  • Spring conference proceeding,
  • 2007

Development of Multi-channel Common Raul Diesel Injector Driver

Y. H. Roh, K. H. Cho
  • Fall conference proceeding,
  • 2004

A Study on the Development of Injector Driver and Pressure Controller for Common Rail Diesel Engine

Y. H. Roh
  • Spring conference proceeding,
  • 2003