Switch-On Modeling and Analysis of Dynamic Wireless Charging System Used for Electric Vehicles

@article{Guo2016SwitchOnMA,
  title={Switch-On Modeling and Analysis of Dynamic Wireless Charging System Used for Electric Vehicles},
  author={Yanjie Guo and Lifang Wang and Qingwei Zhu and Chenglin Liao and Fang Li},
  journal={IEEE Transactions on Industrial Electronics},
  year={2016},
  volume={63},
  pages={6568-6579}
}
This paper presents an equivalent model to analyze switch-on process of dynamic wireless charging system of electric vehicle (EV). In the model, system initial state before switching is considered and the full response is used to describe the switch-on process. First, the system states before and after switching are discussed, and an approximate method is proposed to calculate the initial value of converter dc-side voltage in switch-on unit. Then, equivalent transient sources and system… Expand
Dynamic Wireless Charging of Electric Vehicles: Multi-Channel Modeling
  • A. Khamitov, Batyrbek Alimkhanuly, +4 authors A. P. James
  • Computer Science
  • 2018 IEEE International Conference on Environment and Electrical Engineering and 2018 IEEE Industrial and Commercial Power Systems Europe (EEEIC / I&CPS Europe)
  • 2018
TLDR
This study presents an equivalent model of dynamic wireless charging system of electric vehicles to analyze switch on and switch off processes and modeling and analysis of variable mutual inductance is provided. Expand
Surge Current Analysis of EV Wireless Charging System during Short-circuit Decoupling Process
TLDR
This paper detailly analyzes the dynamic response of the short-circuit decoupling load protection process of the EV wireless charging system, and the analytical relationship between the switching-on moment and the peak value of the Shortcircuit current is derived. Expand
Hybrid Output Regulation of DC-DC Converter for Dynamic Wireless Charging System
TLDR
The control performance of the proposed control schemes are tested through simulation by showing how, as long as the relative distance between the coils increases, the more involved hybrid solutions improve the performances when compared with the more simple continuous-time ones. Expand
Performance Improvement of Control System for Wireless Charging of Electric Vehicle
In this paper, a control strategy is proposed for the wireless charging of electric vehicles (EV) with doubled-sided LCC compensation networks. Despite the conventional chargers, an active rectifierExpand
Transient Control of Dynamic Inductive EV Charging and Impact on Energy Efficiency when Passing a Roadside Coil Section
  • G. Guidi, J. Suul
  • Physics
  • 2018 IEEE PELS Workshop on Emerging Technologies: Wireless Power Transfer (Wow)
  • 2018
This paper discusses the transient control of a system for dynamic inductive power transfer to an electric vehicle when passing a road-side coil section. A series-series-compensated topology withExpand
Charging Area Determining and Power Enhancement Method for Multiexcitation Unit Configuration of Wirelessly Dynamic Charging EV System
TLDR
A power and efficiency enhancement method is proposed by utilizing a multiexcitation unit in the charging area by improving system power capacity without increasing the voltage and current stress. Expand
Neighboring Effects on the Deactivated Inverter in a Segmented Dynamic Wireless EV Charging System
In practical dynamic wireless electric vehicle (EV) charging (DWEVC) applications, the wireless charging roadway is often split into short individually controllable segments; only those segmentsExpand
Dynamic Modeling of Wireless Power Transfer Systems with a Moving Coil Receiver
  • N. Teerakawanich
  • Computer Science
  • 2018 IEEE Transportation Electrification Conference and Expo, Asia-Pacific (ITEC Asia-Pacific)
  • 2018
TLDR
The proposed model adopts the fundamental principle analysis of an electromechanical system that allows the speed of a moving receiver coil to be included for more accurate calculation of transient and steady state responses of the system. Expand
Analysis, Design, and Implementation of Accurate ZVS Angle Control for EV Battery Charging in Wireless High-Power Transfer
TLDR
To suppress the noise in high power, a current hysteresis comparator is adopted, and an enhanced phase detection methodology is proposed to measure the phase of resonant current by using a reference signal produced by a processor. Expand
In-route inductive versus stationary conductive charging for shared automated electric vehicles: A university shuttle service
TLDR
The outcomes show that the proper design of quasi-dynamic inductive chargers at designated stops allows SAEVs to realize unlimited driving range and be cost-competitive to DCFC technology. Expand
...
1
2
3
4
...

References

SHOWING 1-10 OF 28 REFERENCES
Optimal Operation Plan of the Online Electric Vehicle System Through Establishment of a DC Distribution System
Owing to the consistent increase in energy efficiency issues, studies for improving the charging efficiency and energy density of batteries have been receiving attention in the electric vehicleExpand
An Optimized Track Length in Roadway Inductive Power Transfer Systems
Application of inductive power transfer (IPT) to electric vehicles moving along the road can provide more charging flexibility with the reduction of weight and size of charge-storage batteriesExpand
Dynamics Characterization of the Inductive Power Transfer System for Online Electric Vehicles by Laplace Phasor Transform
A large-signal dynamic model of the inductive power transfer system (IPTS) for the online electric vehicle (OLEV) is developed using the recently proposed Laplace phasor transform. With the help ofExpand
The Optimal System Design of the Online Electric Vehicle Utilizing Wireless Power Transmission Technology
  • Young Dae Ko, Y. Jang
  • Engineering, Computer Science
  • IEEE Transactions on Intelligent Transportation Systems
  • 2013
TLDR
A mathematical model and an optimization method to allocate economically the power transmitters and to determine the battery capacity of the OLEV-based mass transportation system are presented and the particle swarm optimization (PSO) algorithm is used as the solution method for the optimization problem. Expand
On-road charging of electric vehicles
  • T. Stamati, P. Bauer
  • Engineering
  • 2013 IEEE Transportation Electrification Conference and Expo (ITEC)
  • 2013
Contactless Power Transfer (CPT) systems are applicable for charging electric vehicles (EVs) without any physical interconnection. These systems can be installed on roadways in order to charge theExpand
Loosely Coupled Transformer Structure and Interoperability Study for EV Wireless Charging Systems
As the wireless power transfer (WPT) technology has been proved to be a convenient and reliable charging method to plug-in hybrid electric vehicles and electric vehicles, the loosely coupledExpand
Demonstrating Dynamic Wireless Charging of an Electric Vehicle: The Benefit of Electrochemical Capacitor Smoothing
The wireless charging of an electric vehicle (EV) while it is in motion presents challenges in terms of low-latency communications for roadway coil excitation sequencing and maintenance of lateralExpand
Dynamic Modeling Based on Coupled Modes for Wireless Power Transfer Systems
A novel dynamic modeling method based on the concept of coupled modes is proposed for wireless power transfer (WPT) systems which use magnetic resonant coupling. The proposed method aims on theExpand
An Approximate Dynamic Model of LCL- $T$-Based Inductive Power Transfer Power Supplies
This paper analyzes the dynamics of an LCL-T-based inductive power transfer power supply, and aims to improve its reference tracking performance for dynamic roadway wireless powering applicationsExpand
Double-Coupled Systems for IPT Roadway Applications
Dynamic powering of in-motion electric vehicles (EVs) using inductive power transfer (IPT) can potentially solve many of the problems currently faced by EVs: in particular range, cost, and chargingExpand
...
1
2
3
...