Susceptibility Mapping

@article{Zaky1992SusceptibilityM,
  title={Susceptibility Mapping},
  author={S. G. Zaky and K. G. Balmain and G. Dubois},
  journal={International Symposium on Electromagnetic Compatibility},
  year={1992},
  pages={439-442}
}
The concept of susceptibility mapping is introduced. A susceptibility map is created by scanning a signal source (loop antenna) over a circuit board, and at each point raising the signal level until failure occurs. Maps obtained with CW EM1 reveal design problems such as tight circuit timing or small static noise margins. They also reveal manufacturing problems, such as bad contacts and faulty chips. This leads to the concept of electromagnetic stress testing. Maps obtained with transient EM1… CONTINUE READING
2 Citations
6 References
Similar Papers

Citations

Publications citing this paper.
Showing 1-2 of 2 extracted citations

References

Publications referenced by this paper.
Showing 1-6 of 6 references

The effects of low-level EMI on digital circuits, M.A.Sc

  • J. F. Chappel
  • thesis, Dept. of Elec. Eng., Univ. of Toronto,
  • 1992

EMI-Induced failures in crystal oscillators,

  • J.-J. Laurin, S. G. Zaky, K. G. Balmain
  • IEEE Trans. on Electromagnetic Compatibility,
  • 1991

EMI-induced failures in digital systems, Ph.D

  • J. J. Laurin
  • thesis, Dept. of Elec. Eng., Univ. of Toronto,
  • 1991

Radiated fast-trnnsient siisceptibility of digital devices,

  • R. E Wallace
  • M.A.Sc. thesis, Dept. of Elec. Eng., Univ. of…
  • 1990

Similar Papers

Loading similar papers…