Study and characterization of SrTiO3 surface

@article{Alarab2018StudyAC,
  title={Study and characterization of SrTiO3 surface},
  author={Fatima Alarab and J{\'a}n Min{\'a}r and Pavol {\vS}utta and Lucie Prusakova and Rostislav Medl{\'i}n and Olivier Heckmann and C. Richter and K Hricovini},
  journal={arXiv: Materials Science},
  year={2018}
}
The two-dimensional electron gas (2DEG) at oxides interfaces and surfaces has attracted large attention in physics and research due to its unique electronic properties and possible application in optoelectronics and nanoelectronics. The origin of 2DEGes at oxide interfaces has been attributed to the well known "polar catastrophe" mechanism. On the other hand, recently a 2DEG was also found on a clean SrTiO3(001) surface where it is formed due to oxygen vacancies. However, these 2DEG systems… Expand
1 Citations

Figures from this paper

Optically Controllable 2D Material/Complex Oxide Heterointerface
TLDR
The 2D material/a‐STO heterostructure could be a potential platform for exploring new functional devices and experiences a dynamic evolution from negative to positive through tuning the light programming time. Expand

References

SHOWING 1-10 OF 26 REFERENCES
Creation and control of a two-dimensional electron liquid at the bare SrTiO3 surface.
TLDR
It is shown that a similar two-dimensional electron gas, with an electron density as large as 8×10(13)  cm(-2), can be formed at the bare SrTiO(3) surface, and that the 2DEG density can be controlled through exposure of the surface to intense ultraviolet light. Expand
Two-dimensional electron gas with universal subbands at the surface of SrTiO3
TLDR
It is shown, using angle-resolved photoemission spectroscopy, that there is a highly metallic universal 2DEG at the vacuum-cleaved surface of SrTiO3 (including the non-doped insulating material) independently of bulk carrier densities over more than seven decades. Expand
High mobility conduction at (110) and (111) LaAlO3/SrTiO3 interfaces
TLDR
It is shown that epitaxial interfaces are not a prerequisite: conducting amorphous LaAlO3 and other oxides can also be prepared and open a new perspective both for materials research and for elucidating the ultimate microscopic mechanism of carrier doping. Expand
A high-mobility electron gas at the LaAlO3/SrTiO3 heterointerface
TLDR
A model interface is examined between two insulating perovskite oxides—LaAlO3 and SrTiO3—in which the termination layer at the interface is controlled on an atomic scale, presenting a broad opportunity to tailor low-dimensional charge states by atomically engineered oxide heteroepitaxy. Expand
Room temperature 2D electron gas at the (001)-SrTiO3 surface
Functional oxides and phenomena such as a 2D electron gas (2DEG) at oxide interfaces represent potential technological breakthroughs for post-CMOS electronics. Non-invasive techniques are required toExpand
The Perovskite SrTiO3 on Si/SiO2 by Liquid Injection MOCVD
SrTiO3, which has a very high dielectric permittivity κ in the form of bulk material (κ ~ 300), has been considered as a potential candidate for the replacement of SiO2-based gate oxide in futureExpand
Structure–Property Relation of SrTiO3/LaAlO3 Interfaces
A large variety of transport properties have been observed at the interface between the insulating oxides SrTiO3 and LaAlO3 such as insulation, 2D interface metallicity, 3D bulk metallicity, magneticExpand
Structural basis for the conducting interface between LaAlO3 and SrTiO3.
The complete atomic structure of a five-monolayer film of LaAlO3 on SrTiO3 has been determined for the first time by surface x-ray diffraction in conjunction with the coherent Bragg rod analysisExpand
Electronic phase separation at the LaAlO₃/SrTiO₃ interface.
TLDR
An EPS state is reported at the LaAlO(3)/SrTiO (3) interface, where the interface charges are separated into regions of a quasi-two-dimensional electron gas, a ferromagnetic phase, which persists above room temperature, and a diamagnetic/paramagnetic phase below 60 K. Expand
Why some interfaces cannot be sharp
A central goal of modern materials physics and nanoscience is the control of materials and their interfaces to atomic dimensions. For interfaces between polar and nonpolar layers, this goal isExpand
...
1
2
3
...