Stochastic finite-fault modeling of ground motions from the June 27, 1998 Adana-Ceyhan earthquake

@article{Yalcinkaya2005StochasticFM,
  title={Stochastic finite-fault modeling of ground motions from the June 27, 1998 Adana-Ceyhan earthquake},
  author={Esref Yalcinkaya},
  journal={Earth, Planets and Space},
  year={2005},
  volume={57},
  pages={107-115}
}
  • E. Yalcinkaya
  • Published 1 February 2005
  • Geology
  • Earth, Planets and Space
In this study, acceleration time histories of the June 27, 1998 Adana-Ceyhan (Turkey) earthquake, are simulated using a stochastic modeling technique for finite faults proposed by Beresnev and Atkinson (1997). The fault length, width and the depth to the top of the fault for the earthquake are assumed 30 km, 21 km and 15 km, respectively, based on the aftershock distribution. Simulations are made for two common site classes: soil and rock. Their response characteristics are obtained from the… 

Strong Ground Motion Simulation for the 2005 Fukuoka Earthquake ( Mw 6 . 6 ) by Stochastic Finite-Fault Simulations

The theoretical basis of the stochastic finite-fault modeling was proposed by Boore (1983) and this technique has been developed by many researchers (g.e., Beresnev and Atkinson, 1997) and many

Stochastic Strong Ground Motion Simulation of the 12 November 1999 Duzce (Turkey) Earthquake Using a Dynamic Corner Frequency Approach

On 12 November 1999, only three months after the 17 August 1999 Kocaeli earthquake (Mw 7:4), an earthquake of Mw 7:1 occurred immediately to the east of the Kocaeli rupture in northwestern Turkey

Site-specific ground motion simulation and seismic response analysis for microzonation of Nanded City, India

We study strong ground motion characteristics and ground response analysis of different sites in Nanded City, India. Synthetic strong ground motion records are obtained for two scenario earthquakes

Site-specific uniform hazard spectrum in Eastern Turkey based on simulated ground motions including near-field directivity and detailed site effects

In this study, stochastic earthquake catalog of the Erzincan region in Turkey is generated based on synthetic ground motions. Monte Carlo simulation method is used to identify the spatial and

Simulation of large earthquakes and its implications on earthquake insurance rates: a case study in Bursa region (Turkey)

Ground motion intensity parameters of past and potential earthquakes are required for a range of purposes including earthquake insurance practice. In regions with no or sparse earthquake recordings,

Seismological and Engineering Demand Misfits for Evaluating Simulated Ground Motion Records

Simulated ground motions have recently gained more attention in seismology and earthquake engineering. Since different characteristics of waveforms are expected to influence alternative structural

Probabilistic Seismic-Hazard Assessment for East Anatolian Fault Zone Using Planar Fault Source Models

The objective of this article is to provide state-of-the-art probabilistic seismic-hazard assessment maps for the East Anatolian fault zone (EAFZ) based on planar seismic-source models and up-to-date

References

SHOWING 1-10 OF 49 REFERENCES

Stochastic Simulation of Strong-Motion Records from the 15 April 1979 (M 7.1) Montenegro Earthquake

Acceleration time histories, recorded during the destructive 15 April 1979 ( M 7.1) Montenegro earthquake, have been simulated using a stochastic modeling technique for finite faults proposed by

Stochastic finite-fault modeling of ground motions from the 1994 Northridge, California, earthquake. I. Validation on rock sites

The stochastic method of simulating ground motions from finite faults is validated against strong-motion data from the M 6.7 1994 Northridge, California, earthquake. The finite-fault plane is

Stochastic finite-fault modeling of ground motions from the 1994 Northridge, California, earthquake. II. Widespread Nonlinear response at soil sites

On average, soil sites behaved nonlinearly during the M 6.7 1994 North- ridge, California, earthquake. This conclusion follows from an analysis that combines elements of two independent lines of

Stochastic Finite-Fault Modeling of Ground Motions from the 1999 Chi-Chi, Taiwan, Earthquake: Application to Rock and Soil Sites with Implications for Nonlinear Site Response

The stochastic method for simulating strong ground motions from finite faults is applied to the records of the 1999 Chi-Chi, Taiwan, earthquake. The method involves discretization of the fault plane

Stochastic Point-Source Modeling of Ground Motions in the Cascadia Region

A stochastic model is used to develop preliminary ground motion relations for the Cascadia region for rock sites. The model parameters are derived from empirical analyses of seismographic data from

Empirical Corrections for Basin Effects in Stochastic Ground-Motion Prediction

Amplification corrections are presented for the finite-fault stochastic ground-motion simulation model; these corrections represent the total effect of the Los Angeles basin on the ground-motion

Attenuation and source parameters of earthquakes in the Cascadia region

  • G. Atkinson
  • Geology
    Bulletin of the Seismological Society of America
  • 1995
Digital ground-motion data recorded by the Western Canada Telemetered Network (WCTN) are used to examine the attenuation and source parameters of earthquakes in the Cascadia region of southwestern