• Engineering
  • Published 2012

Static and modal analyzing for the working table components of a machining center in ANSYS

@inproceedings{Xia2012StaticAM,
  title={Static and modal analyzing for the working table components of a machining center in ANSYS},
  author={Xia and Li-an and Hu and Chun-yang and Bong Koo Han and Jiang},
  year={2012}
}
In this paper,modal analysis theory,equivalent dynamic model of the joint surface of assembly and identification methods of joint surface parameters are the main theories.Static and modal analysis of the working table components of the FM6324 machining center is done.The three-dimensional model of the working table components is established using Pro E at first,then static characteristics is obtained through ANSYS contact analysis;finally,the dynamic model is established in ANSYS,and its… CONTINUE READING