Corpus ID: 2795196

Sorptive Removal of Phosphate From Wastewater Using Activated Red Mud

@inproceedings{ELTayieb2012SorptiveRO,
  title={Sorptive Removal of Phosphate From Wastewater Using Activated Red Mud},
  author={Marwa M. EL-Tayieb and Maha El Shafai and Nouran Y. Mohamed},
  year={2012}
}
Red mud (RM), is a kind of industrial waste produced in the process of alumina production Because of the increasing demand for alumina during economic development, more and more RM is being produced. Hence, the disposal and management of RM remains a challenging issue to the alumina industry. This study examined the effect of acid activated red mud on phosphate removal. Thus, its use in phosphate removal can be also considered as a way of disposal. The removal capacity of RM for phosphate ions… Expand
Simultaneous removal of nitrate and phosphate from wastewater using solid waste from factory
Phosphorous and nitrogen concentration, respectively, between 20–100 and 500–1000 μg/L can cause eutrophication. Thus, developing efficient low-cost removal method is important to protect the aquaticExpand
Potential of Red Mud as an Adsorbent for Nitrogen and Phosphorous Removal in the Petrochemical Industry Wastewater
The increasing of nutrients in wastewater from petrochemical industry is mostly difficult to handle. Particularly, wastewater from this industry contains high level of nitrogen and phosphorus whichExpand
Adsorptive Removal of Phosphate From Wastewater Using Ethiopian Rift Pumice: Batch Experiment
Phosphorous from municipal and industrial wastewater is the main cause of eutrophication of rivers and lakes, because effluent quality from conventional secondary wastewater treatment plants does notExpand
Removal of ammonium and phosphate in the synthetic wastewater using coal fly ash adsorbent
The main composition and availability of fly ash have made this waste potential to be used as an adsorbent for ammonium and phosphate removal. Each composition of fly ash may have different removalExpand
A mechanistic approach to evaluate the effectiveness of red soil as a natural adsorbent for phosphate removal from wastewater
AbstractThe present study was conducted to investigate the efficacy of red soil (RS), as a natural adsorbent, for phosphate removal from wastewater. The chemical composition of the adsorbent wasExpand
The influences on the Phosphate Removal from Aqueous Solution by using red mud
This paper highlights the result obtained in the study of phosphate removal by heat modified red mud at 400oC in 1 hour. These results pointed that under the conditions of pH 7.0, heat modified redExpand
Studies on adsorption behavior of an industrial waste for removal of chromium from aqueous solution
Abstract An investigation on the adsorption characteristics of an industrial waste (Dolochar) for removal of Cr (VI) from aqueous solutions was studied varying various parameters such as contactExpand
Design Phosphate Removal Technology using Volcanic Rocks: Kinetics and Equilibrium Studies
− In this work adsorption of P(V) on to Scoria (VSco) and Pumice (VPum) has been studied by using a batch method at room temperature. The effect of various design parameters, i.e. contact time,Expand
The Comparison of Red Mud Modification by Acid and Heat for Phosphate Removal from Aqueous Solution
This paper highlights the result obtained from red mud modification by chemical and heat methods. These results pointed that at the same conditions of pH 7.0, modified red mud dose 10g/L, contactExpand
Removal of fluoride from water using H2O2-treated fine red mud doped in Zn-alginate beads as adsorbent
Abstract Beads prepared by entrapping H2O2-treated fine red mud in the zinc-alginate (RMZAB), are investigated as adsorbent for their sorption nature towards the fluoride ions from water.Expand
...
1
2
...

References

SHOWING 1-10 OF 53 REFERENCES
Adsorption removal of phosphate from aqueous solution by active red mud.
TLDR
The result showed that the red mud sample treated using acid-heat method at 80 degrees C with 0.25 mol/L HCl for 2 h achieved the highest phosphate removal, and pH 7 was the optimal pH for phosphate removal. Expand
Adsorption removal of phosphate from aqueous solution by active red mud.
Red mud is the waste of alumina industry and has high TiO2 and Fe2O3 content which are active components for the adsorption of anion pollutants. In this study, the uptake of phosphate by red mudExpand
Phosphate removal from aqueous solutions using raw and activated red mud and fly ash.
TLDR
The result shows that a higher efficiency of phosphate removal was acquired by the activated samples than by the raw ones, and the Langmuir model has a better correlation with the experimental data than the Freundlich model. Expand
Research on the characteristics of red mud granular adsorbents (RMGA) for phosphate removal.
TLDR
Red mud (RM), a waste tailing from alumina industry, was employed with bentonite and starch as the main raw materials for producing granular adsorbents in this study, and it was speculated that the increase in ST could lead to qualitative diversification on the surface and quantitative decrease of effective components for adsorption simultaneously. Expand
Removal of phosphate species from solution by adsorption onto calcite used as natural adsorbent.
TLDR
P pH plays an important role in the removal of phosphate species from solution, with removal being more efficient in the basic pH region, and adsorption is also efficient for high ratios phosphate/adsorbent. Expand
Removal of fluoride from water by using granular red mud: Batch and column studies.
TLDR
The Redlich-Peterson and Freundlich isotherm models better represented the adsorption data in comparison to the Langmuir model and they were in agreement with the corresponding experimental data. Expand
Removal of phosphate from wastewaters
Abstract Gas concrete waste was used to remove phosphate from aqueous solutions in this study. The influence of suspension pH, temperature, mixing rate, and gas concrete dosage on phosphate removalExpand
Removal of hexavalent chromium from aqueous solution by agricultural waste biomass.
TLDR
The results showed that studied adsorbents can be an attractive low cost alternative for the treatment of wastewaters in batched or stirred mode reactors containing lower concentrations of chromium. Expand
Removal of toxic metal Cr(VI) from aqueous solutions using sawdust as adsorbent: Equilibrium, kinetics and regeneration studies
Abstract In the present study, a low-cost adsorbent is developed from the naturally and abundantly available sawdust which is biodegradable. The removal capacity of Cr(VI) from aqueous solutions andExpand
Phosphate removal from water by red mud using crossflow microfiltration
Abstract Red mud (which is a waste material formed during the production of alumina and primarily contains ferric and aluminium oxides) was used as an adsorbent for the removal of phosphate ions fromExpand
...
1
2
3
4
5
...