Screening and Domestication of Microorganism Used in Oil Contaminated Wastewater Remediation

@article{Xu2009ScreeningAD,
  title={Screening and Domestication of Microorganism Used in Oil Contaminated Wastewater Remediation},
  author={Xinyang Xu and Xi Chen},
  journal={2009 3rd International Conference on Bioinformatics and Biomedical Engineering},
  year={2009},
  pages={1-4}
}
  • Xinyang Xu, Xi Chen
  • Published 11 June 2009
  • Engineering
  • 2009 3rd International Conference on Bioinformatics and Biomedical Engineering
According to the characteristics of oil contaminated wastewater, four strains of microorganism, named TA-11, TA-17, HA-9, HD-1, which can degrade oil and COD Cr of oil contaminated wastewater were picked out from the oil contaminated soil and activated sludge of Panjin pitch plant wastewater treatment system. The research results showed four strains of microorganism can all remove oil and COD Cr . in oil contaminated wastewater effectively, the highest removal ratio of COD Cr after 64 hours was… 
1 Citations

Figures and Tables from this paper

Preparation and Application of Polymer Silicate Phosphate Ferric Sulfate Used in High-Viscosity Oil Refining Wastewater Treatment
A new kind of flocculants, named Polymer Silicate Phosphate Ferric Sulfate(PSPFS), was synthesized by ferrous sulfate used as the main material and activated silicic acid as additive. In this paper,

References

SHOWING 1-8 OF 8 REFERENCES
Chemical Embedding Immobilization Technique of Micrococcus sp. Used in Contaminated Surface Water Remediation
According to the characteristics of contaminated surface water, a stain of Micrococcus sp. (Micrococcus sp. N3-9P) that could remove CODCr efficiently was picked out from the slowly flowing
Recovery of residual emulsifiable oil from waste water by flotation
A source of waste‐water pollution in machining is the lubricating/cooling fluid used. This study investigates the application of the flotation technique for the removal of emulsifiable oil. Research
Removal of oil, grease, and suspended solids from produced water with ceramic crossflow microfiltration
In this paper results of studies of two onshore and two offshore pilot plants that use ceramic crossflow microfiltration (CCFM) to separate oil, grease, and suspended solids from produced water are
Oil recovery from oil in water emulsions using a flotation column
A flotation column was used to recover oil from oil in water emulsions. The feed oil concentrations investigated were relatively high, in the range of 0.25 to 8 percent by volume. Previous studies
MICROSCOPIC CHARACTERIZATION OF OIL DROPLETS REMOVED BY FLOCS AFTER COAGULATION OF OIL–WATER EMULSIONS
  • B. Tansel, Vesna Dimitric-Clark
  • Engineering
    Journal of environmental science and health. Part A, Toxic/hazardous substances & environmental engineering
  • 2002
TLDR
The size distribution of the droplets which were attached on the flocs showed a significantly skewed pattern towards the smaller diameter droplets indicating that there is a characteristic droplet size range for attachment of droplets on the forming flocS.
Status of research and application of the oily wastewater treatment technology[J], Shanghai
  • Chemical Industry,
  • 2003
A Course of Microbiology experiment [M
  • Science press,
  • 2004