SYNTHESIS AND CHARACTERIZATION OF CuWS2 SPRAY PYROLYSIS IN THIN FILMS
@inproceedings{Muthukrishnan2017SYNTHESISAC, title={SYNTHESIS AND CHARACTERIZATION OF CuWS2 SPRAY PYROLYSIS IN THIN FILMS}, author={S. Muthukrishnan and Venkatraman Subramaniam and Thaiyan Mahalingam and P. Sumathi and S. J. Helen and V. Senthil Kumar and B. Janarthnan and Caitlin Thirunavukarasu}, year={2017} }
Copper doped Tungsten disulphide (CuWS2) thin films have been synthesized on to glass substrates at 400°C temperatures by spray pyrolysis technique from aqueous solution using cupric acetate Cu (CH3COO)2.H2O as a precursor. The structure of the deposited CuWS2 thin films characterized by X-ray diffraction, the surface morphology was observed by a scanning electron microscope,the optical transmission and absorption spectra was recorded by ultraviolet visible spectroscopy was studied. All the…
References
SHOWING 1-10 OF 24 REFERENCES
Nanocrystalline CuO thin films: synthesis, microstructural and optoelectronic properties
- Materials ScienceJournal of Materials Science: Materials in Electronics
- 2012
Nanocrystalline copper oxide (CuO) thin films have been synthesized by a sol–gel method using cupric acetate Cu (CH3COO) as a precursor. The as prepared powder was sintered at various temperatures in…
Use of low-temperature nanostructured CuO thin films deposited by spray-pyrolysis in lithium cells
- Materials Science
- 2005
Physical properties of nanocrystalline CuO thin films prepared by the SILAR method
- Materials Science, Physics
- 2013
Preparation and characterization of obliquely deposited copper oxide thin films
- Materials Science
- 2007
When a thin film is deposited by physical vapour deposition, with the vapour flux arriving at an oblique angle from the substrate normal, and under conditions of sufficiently limited adatom mobility…
Producing CuO and ZnO composite thin films using the spin coating method on microscope glasses
- Materials Science
- 2013
Electrical and optical properties of highly conducting CdO:F thin film deposited by sol–gel dip coating technique
- Materials Science
- 2004