• Corpus ID: 59322743

STRUCTURAL AND ELECTRICAL CHARACTERIZATION OF SINTERED SnTe FILMS

@inproceedings{Saini2010STRUCTURALAE,
  title={STRUCTURAL AND ELECTRICAL CHARACTERIZATION OF SINTERED SnTe FILMS},
  author={Raman Kumar Saini{\^a} and Mrittika Singha and Ravi Kumarb and G. JAINa},
  year={2010}
}
The effective deposition techniques of good quality SnTe films over a large area have been of increasing interest in many optoelectronic applications exp. infrared detectors and solar cells. Tin telluride was prepared by mechanical alloying technique and the films were deposited by an inexpensive and commerciably viable sintering technique on glass substrate. The structural and electrical properties of these films have been examined to investigate the utility of the material for different… 
4 Citations

Figures and Tables from this paper

Structural, Thermal, Optical, and Photoacoustic Study of Mechanically Alloyed Nanocrystalline SnTe
A nanostructured SnTe phase was produced by mechanical alloying after 2 h of milling. Part of the as-milled powder was annealed and its X-ray diffraction (XRD) pattern was recorded. The XRD patterns
Principle Investigation of Structural, Electronics and Chemical Properties of Sn Doped PbX (X=S, Se, Te)
The Structural, electronic and chemical bonding of the Sn doped PbX (X=S, Se, Te) are calculated by full potential linearized augmented plane wave method (FP-LAPW) within density functional theory
PREPARASI DAN KARAKTERISASI LAPISAN TIPIS Sn(S0,5Te0,5) DENGAN TEKNIK EVAPORASI VAKUM PREPARATION AND CHARACTERIZATION OF THIN FILM Sn(S0,5 Te0,5) WITH VACUM EVAPORATION TECNIQUES
Abstrak Penelitian ini bertujuan untuk mengetahui pengaruh suhu substrat terhadap kualitas lapisan tipis Sn(S0,5Te,5), mengetahui struktur kristal, parameter kisi, morfologi permukaan dan komposisi

References

SHOWING 1-10 OF 10 REFERENCES
Material science and engineering : an introduction
TLDR
Economic, Environmental, and Societal Issues in Materials Science and Engineering andMaterials Selection and Design Considerations.
SEMICONDUCTOR MATERIALS :-
The label semiconductor itself provides a hint as to its characteristics. The prefix semis normally applied to a range of levels midway between two limits. The term conductor is applied to any
Semimetals & narrow-bandgap semiconductors
Wolfgang Heiss
  • V. Shevchenko Elean, Jong-Soo Lee, Haraid Schwinghammer, A. Paul Alivisatos, and V.Talapin Dmitri J. AM. Chem Soc. 129(37) 11354
  • 2007
Phys
  • Rev. 131, 104
  • 1963
Materials Today 11(11)
  • 28
  • 2008
Phy
  • Latters 84 (13)
  • 2004
Shevchenko Elean , Jong - Soo Lee , Haraid Schwinghammer , A . Paul Alivisatos , and V
  • Talapin Dmitri J . AM . Chem Soc .
  • 2007
Monika Singh
  • R. Kumar and G. Jain, Optoelectron. Adv. Mater.-Rapid Comm. 3(1) 49
  • 2009
) . [ 13 ] V . Raghavan , Material Science and Engineering , fifth eddition Feb ( 2005 ) . [ 14 ] V . Patkov
  • Adv . Mater . - Rapid Comm .
  • 2009