• Corpus ID: 55637641

SPRAY FORMING AND TRIBOLOGICAL BEHAVIOUR OF SiC PARTICLE REINFORCED Al-Si ALLOY Thesis submitted in partial fulfilment of the requirement for The award of the degree of Master of Technology (M. Tech)

@inproceedings{2010SPRAYFA,
  title={SPRAY FORMING AND TRIBOLOGICAL BEHAVIOUR OF SiC PARTICLE REINFORCED Al-Si ALLOY Thesis submitted in partial fulfilment of the requirement for The award of the degree of Master of Technology (M. Tech)},
  author={},
  year={2010}
}
  • Published 2010
  • Materials Science
We are emphasizing our work on near eutectic Al-Si alloys. In the present study spray forming route is adopted to manufacture SiC particle reinforced LM13 alloy. Tribologic properties of these alloy under dry sliding were analyzed experimentally. Dry sliding wear behaviour of LM13 alloy and its composites reinforced with SiC particles was studied using a pin-on-disc machine. EN31 steel was used as the disc material in the wear tester. Tests were done at 50°C and 75°C temperature under the load… 

Figures and Tables from this paper

References

SHOWING 1-10 OF 13 REFERENCES

Aluminium matrix composites: Challenges and opportunities

Aluminium matrix composites (AMCs) refer to the class of light weight high performance aluminium centric material systems. The reinforcement in AMCs could be in the form of continuous/discontinuous

Yang,“Method for spray forming a metal component and a spray formed metal

  • 2009

Grant,“Metallurgical and Materials Transactions

  • 2007

P.Yan, “An aluminum alloy metal matrix discontinuously reinforced with silicon carbide particulates”(1995)

  • 1995

Grant,“The Minerals”,“Metals & Materials Society and ASM International

  • 2007

Harris,“New Light Alloys”,(1990)4-21

  • 1990

Spray Forming Progress in material science”,39(1995)497-545

  • 1995

R.Mehrabian,“Composite of aluminium alloys: fabrication and wear behaviour”,“Journal Material Science”17(1982)477-98

  • 1982