• Engineering
  • Published 2009

SIMULATION RESULTS OF EIGHT BUS SYSTEM USING PUSH-PULL INVERTER BASED STATCOM

@inproceedings{Usha2009SIMULATIONRO,
  title={SIMULATION RESULTS OF EIGHT BUS SYSTEM USING PUSH-PULL INVERTER BASED STATCOM},
  author={N. Usha},
  year={2009}
}
This paper deals with modeling and simulation of Voltage Source Inverter based STATCOM using Push-Pull inverter. The eight bus system is modeled and simulated using sim power system block set. Creation of voltage sag and compensation using STATCOM in eight bus system are presented. The present work proposes push-pull inverter for the control of STATCOM.The comparison of multi bus System with and without STATCOM is also presented. 

References

Publications referenced by this paper.
SHOWING 1-7 OF 7 REFERENCES

Introduction to Series Connected multiconverter System

S.Fakuda, Y.Kubo, Li Dongsheng
  • IEEE IAS’02-2002
  • 2002
VIEW 1 EXCERPT

solutions to power quality problems” power engineering journal

Ray Arnold
  • 2001
VIEW 1 EXCERPT

Dynamic voltage restoration with minimum energy injection

  • 2000 IEEE Power Engineering Society Winter Meeting. Conference Proceedings (Cat. No.00CH37077)
  • 2000

Modeling and simulation of a distribution STATCOM using simulink ’ s power system blockset ” , in proc

G. Sybille
  • 1998