Ripple current cancellation circuit

@article{Schutten2003RippleCC,
  title={Ripple current cancellation circuit},
  author={M. Schutten and R. Steigerwald and J. Sabate},
  journal={Eighteenth Annual IEEE Applied Power Electronics Conference and Exposition, 2003. APEC '03.},
  year={2003},
  volume={1},
  pages={464-470 vol.1}
}
A ripple current cancellation technique injects AC current into the output voltage bus of a converter that is equal and opposite to the normal converter ripple current. The output current ripple is ideally zero, leading to ultra-low noise converter output voltages. The circuit requires few additional components, no active circuits are required. Only an additional filter inductor winding, an auxiliary inductor, and small capacitor are required. The circuit utilizes leakage inductance of the… Expand
Ripple current cancellation for boost converters
A Spur-Reduction DC–DC Converter With Active Ripple Cancelation Technique
Design of zero-voltage-ripple buck dc-dc converter
Isolated current doubler with multiple levels of ripple cancellation
  • M. E. Jacobs
  • Engineering
  • INTELEC 2008 - 2008 IEEE 30th International Telecommunications Energy Conference
  • 2008
Hybrid structured buck converter with ripple cancellation and improved efficiency
Ripple cancellation technique applied to a synchronous buck converter to achieve very high bandwidth and very high efficiency envelope amplifier
Self-driven Active-Clamped Forward Power Converter with Output Ripple-Cancellation for Aerospace Applications
Input Current Ripple Cancellation Technique for Boost Converter Using Tapped Inductor
...
1
2
3
4
5
...

References

SHOWING 1-8 OF 8 REFERENCES
Novel aspects of an application of 'zero'-ripple techniques to basic converter topologies
  • J. Kolar, H. Sree, N. Mohan, F. Zach
  • Engineering
  • PESC97. Record 28th Annual IEEE Power Electronics Specialists Conference. Formerly Power Conditioning Specialists Conference 1970-71. Power Processing and Electronic Specialists Conference 1972
  • 1997
Improved small-signal analysis for the ZVT converter
  • M. Schutten, D. Torrey
  • Engineering
  • APEC 2001. Sixteenth Annual IEEE Applied Power Electronics Conference and Exposition (Cat. No.01CH37181)
  • 2001
Input filter design for power factor correction circuits
Design considerations for high-voltage high-power full-bridge zero-voltage-switched PWM converter
A 'zero' ripple technique applicable to any DC converter
  • D. C. Hamill, P. Krein
  • Engineering
  • 30th Annual IEEE Power Electronics Specialists Conference. Record. (Cat. No.99CH36321)
  • 1999
Smallsignal analysis of zero-voltage switched full-bridge PWM converter
  • High Frequency Power Conversion Conf., 1990, pp. 262- 272
  • 1990
A 500 kHz, 250 W DC- DC converter with multiple outputs controlled by phase-shifted PWM and magnetic amplifiers
  • High Frequency Power Conversion Conf., 1988, pp. 100-110
  • 1988