Corpus ID: 118609285

R&D STATUS OF ATF2 IP BEAM SIZE MONITOR (SHINTAKE MONITOR)

@article{Suehara2007RDSO,
  title={R\&D STATUS OF ATF2 IP BEAM SIZE MONITOR (SHINTAKE MONITOR)},
  author={Taikan Suehara and Hakutaro Yoda and Masahiro Oroku and Takashi Yamanaka and Sachio Komamiya and Tomoyuki Sanuki and Toshiaki Tauchi and Yosuke Honda and Tatsuya Kume},
  journal={arXiv: Accelerator Physics},
  year={2007}
}
Shintake monitor[2] is a nanometer-scale electron beam size monitor. It probes a electron beam by an interference fringe pattern formed by split laser beams. Minimum measurable beam size by this method is less than 1/10 of laser wavelength. In ATF2, Shintake monitor will be used for the IP beam size monitor to measure 37 nm (design) beam size. Development status of the Shintake monitor, including fringe phase monitoring and stabilization, gamma detector and collimators, is described. In… Expand

Figures and Tables from this paper

A micron-scale laser-based beam profile monitor for the international linear collider
A micron-scale laser-wire system was constructed and tested at the Accelerator Test Facility (ATF) extraction line at the High Energy Accelerator Research Organisation (KEK) in Japan. The system wasExpand
Beam-Based Alignment, Tuning and Beam Dynamics Studies for the ATF2 Extraction Line and Final Focus System
Using a new extraction line currently under construction, the ATF2 experiment plans to test the novel compact final focus optics design with local chromaticity correction intended for use in futureExpand
Linear collider test facility: ATF2 final focus active stabilisation pertinence
Beam motion at the Interaction Point (IP) of ATF2 has to be less than 10nm relative to the instrumentation used for measurements. Due to ground motion (GM), the beam can pass off-axis through theExpand
Feedback Corrections for Ground Motion Effects at ATF2
TLDR
A method using SVD-determined knobs and how it can be implemented in ATF2 are described, to provide beams with a few tens of nanometers and stability at the nanometer level. Expand
Implementation and validation of the linear collider final focus prototype : ATF2 at KEK (Japan)
A future e+/e− linear collider is planned to be built in order to obtain precise measurements (at the TeV scale) which would be complementary to the ones from the LHC. One of the challenges of thisExpand

References

SHOWING 1-6 OF 6 REFERENCES
Third ATF2 Project Meeting (2006) http://ilcagenda.linearcollider.org/contributionDisplay.py?contribId=7&materialId=slides&confId=1295 LCWS/ILC2007
  • 2007
Third ATF2 Project Meeting
  • Third ATF2 Project Meeting
  • 2006
Proc
  • Proc
  • 2005
Proc
  • Proc
  • 1995
Nucl
  • Inst. and Meth., A311 455
  • 1992
Nucl. Inst. and Meth
  • Nucl. Inst. and Meth
  • 1992