Optical orientation determination for airborne and spaceborne line cameras

@inproceedings{Wohlfeil2012OpticalOD,
  title={Optical orientation determination for airborne and spaceborne line cameras},
  author={J{\"u}rgen Wohlfeil},
  year={2012}
}
  • J. Wohlfeil
  • Published 16 January 2012
  • Environmental Science
Airborne and spaceborne line cameras allow a very economic acquisition of high- resolution and wide swath images of the Earth. They generate two-dimensional images while rotating or translating, which causes a non-rigid image geometry. Non- uniform motion of the camera can negatively affect the image quality. Due to this, a key requirement for line cameras is that fast orientation changes have to be avoided or measured with a very high rate and precision. Camera stabilization is not always… 

Fully Automated Generation of Accurate Digital Surface Models with Sub-Meter Resolution from Satellite Imagery

Modern pixel-wise image matching algorithms like Semi-Global Matching (SGM) are able to compute high resolution digital surface models from airborne and spaceborne stereo imagery. Although image

Extrinsic Parameter Calibration for Line Scanning Cameras on Ground Vehicles with Navigation Systems Using a Calibration Pattern

A novel method that estimates the camera’s pose relative to the navigation system and several approaches to displaying and interpreting the 6D results in a human readable way are proposed.

References

SHOWING 1-10 OF 50 REFERENCES

Block Triangulation using Three-line Images

  • T. Ohlhof
  • Environmental Science, Mathematics
  • 2001
The usefulness of the 3-line camera concept and the applicability of the proposed mathematical models of point determination have been proven with practical airborne MEOSS and spaceborne MOMS-02 imagery and computer simulations have turned out that the most accurate results can be obtained by simultaneous block adjustment of multiple overlapping and additional crossing strips.

Optical orientation measurement for remote sensing systems with small auxiliary image sensors

An approach for an auxiliary orientation measurement system that is able to measure a remote sensing system’s orientation changes with both, a very high rate and appropriate precision and is compared to the reference measurements of a high-end INS/GPS system.

Geometric Processing Of High Resolution Airborne Scanner Imagery Using GPS-INS And Ground Control Po

The registration and geometric recti cation of airborne scanner imagery is an essential prerequisite for the processing and analysis of this type of images. The Digital Photogrammetric Assembly (DPA)

High Precision Georeferencing using GPS/INS and Image Matching

The registration and geometric recti cation of airborne scanner imagery is an essential prerequisite for the processing and analysis of this type of images. The Digital Photogrammetric Assembly (DPA)

Improvement of Spatial Resolution with Staggered Arrays As Used in The Airborne Optical Sensor Ads40

Using pushbroom sensors onboard aircrafts or satellites requires, especially for photogrammetric applications, wide image swaths with a high geometric resolution. One approach to satisfy both demands

IMPROVEMENT OF INTERIOR AND EXTERIOR ORIENTATION OF THE THREE LINE CAMERA HRSC WITH A SIMULTANEOUS ADJUSTMENT

Since January 2004 the High Resolution Stereo Camera (HRSC) on board the ESA Mission Mars Express (MEX) is imaging the surface of planet Mars in color and stereoscopically in high resolution. As part

SENSOR MODELING FOR AERIAL MOBILE MAPPING WITH THREE-LINE- SCANNER (TLS) IMAGERY

This paper describes the sensor modeling and the photogrammetric triangulation procedure for the TLS (Three-Line-Scanner) system. This system is a new airborne digital sensor developed by STARLABO,

Investigation into Self-calibration Methods for the Vexcel UltraCam D Digital Aerial Camera

This paper provides an investigation into the camera calibration of a Vexcel UltraCam D digital aerial camera which was undertaken as part of the EuroSDR Digital Camera Calibration project. This

MFC - A Modular Line Camera for 3D World Modulling

The state of the art stereo matching algorithms are of prime importance, therefore the applied semi-global matching is described shortly and the quality of data products will be evaluated.