Nonlinear control of wind power generation systems
@article{Guo2009NonlinearCO, title={Nonlinear control of wind power generation systems}, author={Yi Guo and John N. Jiang and Choon Yik Tang}, journal={2009 IEEE/PES Power Systems Conference and Exposition}, year={2009}, pages={1-7} }
This paper proposes a nonlinear control design technique for wind generation systems that deals with both active power and reactive power at the same time in consideration of the fact that the wind generation system is a high order nonlinear dynamical system. Unlike the existing controller designs, the proposed technique is developed based on original nonlinear models of electric machine and wind turbine, and does not use any linear assumption. In addition to the desired reactive power control…
12 Citations
Modeling and controller design of a wind energy conversion system with matrix converter
- EngineeringICWET
- 2011
The controller is tuned for fault current limitation and optimal power flow in WECS, and the Space Vector Modulation technique is used for matrix converter to control the generator rotor current.
Modeling, control and analysis of a Doubly Fed Induction Generator based wind turbine system with voltage regulation
- Engineering
- 2011
Wind power is the most reliable and developed renewable energy source. The share of wind power with respect to total installed power capacity is increasing worldwide. The Doubly Fed Induction…
MODELING AND CONTROL OF HYBRID PHOTOVOLTAIC - WIND ENERGY CONVERSION SYSTEM
- Engineering
- 2012
This paper proposes a hybrid energy conversion system combing photovoltaic and wind turbine as a small-scale alternative source of electrical energy where conventional generation is not practical.…
Modeling and Control of Variable Pitch and Variable Speed Wind Turbine by using Matrix Converter
- Engineering
- 2011
In order to meet increasing power demand, taking into account economical and environmental factors, wind energy conversion is gradually gaining interest as a suitable source of renewable energy. In…
Design of Multi-input Converter for a Hybrid PV/Wind power Generation System and I-PVSC for Battery Charging and MATLAB Software
- Engineering
- 2017
This paper presents a multi-input converter (MIC) for hybrid PV/wind power charger system which can simplify the power system, and also I-PVSC is used for charging of battery. reduce the cost,…
Comparison of the Performance of Vector Control and Direct Power Control of Induction Generator in Wind Energy Conversion System
- Engineering
- 2012
WIND ENERGY CONVERSION SYSTEM
- Engineering
- 2012
This paper proposes a hybrid energy conversion system combing photovoltaic and wind turbine as a small-scale alternative source of electrical energy where conventional generation is not practical.…
Fuzzy logic based indirect vector control of induction generator in Wind Energy Conversion System
- Engineering2012 International Conference on Power, Signals, Controls and Computation
- 2012
In order to meet increasing power demand, taking into account economical and environmental factors, wind energy conversion is gradually gaining interest as a suitable source of renewable energy. The…
DIRECT TORQUE CONTROL OF DOUBLY FED INDUCTION GENERATOR BASED WIND TURBINE UNDER VOLTAGE DIPS
- Engineering
- 2012
This paper focuses the analysis on the control of doubly fed induction generator (DFIG) based high-power wind turbines when they operate under presence of voltage dips. The main objective of the…
Maximum Power point Tracking in Hybrid Photo-voltaic and Wind Energy Conversion System
- Engineering
- 2012
This paper proposes a hybrid energy conversion system combing photovoltaic and wind turbine as a smallscale alternative source of electrical energy where conventional generation is not practical. The…
References
SHOWING 1-10 OF 37 REFERENCES
Active Power Control Strategies of DFIG Wind Turbines
- Engineering2007 IEEE Lausanne Power Tech
- 2007
This paper is devoted to the active power control of DFIG wind turbines. An adaptation of the usual power set point control has been proposed in order to improve the transient behavior for high wind…
Sliding Mode Power Control of Variable Speed Wind Energy Conversion Systems
- Engineering2007 IEEE International Electric Machines & Drives Conference
- 2007
This paper addresses the problem of controlling power generation in variable speed wind energy conversion systems (VS-WECS). These systems have two operation regions depending on wind turbines tip…
Sensorless multiscalar control of double fed machine for wind power generators
- EngineeringProceedings of the Power Conversion Conference-Osaka 2002 (Cat. No.02TH8579)
- 2002
The control system based on the multiscalar model of the double fed machine is presented in the paper. Nonlinear feedback transforms the system into two independent linear subsystem. Estimation of…
Control of variable-speed wind turbines: standard and adaptive techniques for maximizing energy capture
- EngineeringIEEE Control Systems
- 2006
The question of theoretical stability of the torque controller is addressed, showing that the rotor speed is asymptotically stable under the torque control law in the constant wind speed input case and L/sub 2/ stable with respect to time-varying wind input.
Nonlinear robust control to maximize energy capture in a variable speed wind turbine
- Engineering2008 American Control Conference
- 2008
A series of numerical results show that the wind turbine can be controlled to achieve maximum energy capture.
Novel power error vector control for wind turbine with doubly fed induction generator
- Engineering30th Annual Conference of IEEE Industrial Electronics Society, 2004. IECON 2004
- 2004
This paper proposes a new control method for a doubly fed induction generator. The control is suited for variable speed operation where stator active and reactive power control is required,…
Optimal active and reactive power control with the doubly-fed induction generator in the MW-class wind-turbines
- Engineering4th IEEE International Conference on Power Electronics and Drive Systems. IEEE PEDS 2001 - Indonesia. Proceedings (Cat. No.01TH8594)
- 2001
In this work control strategies for a wind generation system are studied. A wound rotor induction machine is used with two back-to-back converters on the rotor circuit in a slip power recovery…
Direct Power Control of DFIG With Constant Switching Frequency and Improved Transient Performance
- EngineeringIEEE Transactions on Energy Conversion
- 2007
This paper proposes a new direct power control (DPC) strategy for a doubly fed induction generator (DFIG)-based wind turbine system. The required rotor control voltage, which eliminates active and…
Improving transition between power optimization and power limitation of variable speed, variable pitch wind turbines using fuzzy control techniques
- Engineering, Computer Science2000 26th Annual Conference of the IEEE Industrial Electronics Society. IECON 2000. 2000 IEEE International Conference on Industrial Electronics, Control and Instrumentation. 21st Century Technologies
- 2000
A computational fuzzy model is presented for a variable speed, variable pitch wind turbine and results show an excellent performance improving transition between power optimization and power limitation of the wind turbine, specially in the rated wind speed working conditions.
Pitch control of large scale wind turbine based on fuzzy-PD method
- Engineering2008 Third International Conference on Electric Utility Deregulation and Restructuring and Power Technologies
- 2008
The wind turbine operating area can be divided into several regions, depending on wind speed. The control objectives are different for each operating region. This paper mainly deals with the control…