Modelling of surface finish and tool flank wear in turning of AISI D 2 steel with ceramic wiper inserts

@inproceedings{zel2007ModellingOS,
  title={Modelling of surface finish and tool flank wear in turning of AISI D 2 steel with ceramic wiper inserts},
  author={T. {\"O}zel and Y. Karpat and Luı́s Figueira and J. Paulo Davim},
  year={2007}
}
Tool nose design affects the surface finish and productivity in finish hard turning processes. Surface finishing and tool flank wear have been nvestigated in finish turning of AISI D2 steels (60 HRC) using ceramic wiper (multi-radii) design inserts. Multiple linear regression models and eural network models are developed for predicting surface roughness and tool flank wear. In neural network modelling, measured forces, power nd specific forces are utilized in training algorithm. Experimental… CONTINUE READING

Citations

Publications citing this paper.
Showing 1-10 of 25 extracted citations

References

Publications referenced by this paper.
Showing 1-10 of 20 references

Machinability evaluation in hard turning of cold work tool steel ( D 2 ) with ceramic tools using statistical techniques

  • J. P. Davim, L. Figueira
  • J . Mater . Des .
  • 2007

Advanced tool edge geometry for high precision hard turning

  • F. Klocke, H. Kratz
  • Ann. CIRP
  • 2005
3 Excerpts

Hard turning : AISI 4340 high strength low alloy steel and AISI D 2 cold work tool steel

  • J. G. Lima, R. F. Avila, A. M. Abrao, M. Faustino, J. P. Davim
  • J . Mater . Process . Technol .
  • 2005

Hard turning of quenched alloy steel parts using conventional and wiper ceramic inserts

  • W. Grzesik, T. Wanat
  • Trans . NAMRI / SME
  • 2005

Tool nose radius effects on finish hard turning

  • Y. K. Chou, H. Song
  • J . Mater . Process . Technol .
  • 2004

Experimental investigation on CBN turning of AISI 52100 steel

  • Y. K. Chou, C. J. Evans, M. M. Barash
  • J . Mater . Process . Technol .
  • 2003

Cutting tool wear in the machining of hardened steels .

  • J. Barry, G. Byrne
  • Part II . CBN cutting tool wear , Wear
  • 2001

Cutting hardened steel

  • H. K. Toenshoff, C. Arendt, R. Ben Amor
  • Ann. CIRP 49/2
  • 2000
2 Excerpts

Similar Papers

Loading similar papers…