Modeling of Bulk Current Injection ( BCI ) Setups for Virtual Automotive IC Tests

@inproceedings{Miropolsky2010ModelingOB,
  title={Modeling of Bulk Current Injection ( BCI ) Setups for Virtual Automotive IC Tests},
  author={Sergey Miropolsky and Stephan Frei and J{\"o}rg Frensch},
  year={2010}
}
The Bulk Current Injection (BCI) method is widely used for RF immunity testing of automotive systems and ICs in electronics industry. During testing detected IC failures may lead to expensive redesigns and cause seriously delays of a product launch. To evaluate the chip immunity in early design stages it is desired to perform virtual tests based on accurate models. In this paper an accurate and fast to simulate behavioural model of a BCI injection clamp is presented. The applicability is shown… CONTINUE READING

Citations

Publications citing this paper.
Showing 1-10 of 13 extracted citations

References

Publications referenced by this paper.
Showing 1-5 of 5 references

Pignari, "SPICE modeling of BCI probes accounting for the frequency-dependent behavior of the ferrite core

  • F. Grassi, F. Marliani, A S.
  • in Proc. XIXth General Assembly of U.R.S.I…
  • 2008
Highly Influential
4 Excerpts

Injection probe modeling for bulk current injection test on multiconductor transmission lines

  • F. Lafon, Y. Belakhouy, F. De Daran
  • IEEE Symp. on Embedded EMC Proceedings, Rouen…
  • 2007
2 Excerpts

Similar Papers

Loading similar papers…