Mass Transfer around Active Particles in Fluidized Beds

@inproceedings{Scala2011MassTA,
  title={Mass Transfer around Active Particles in Fluidized Beds},
  author={F. Scala},
  year={2011}
}
Fluidized beds are extensively used in a number of gas-solid applications where significant heat and/or mass transfer rates are needed. The design and modelling of such processes requires the precise knowledge of the heat and mass transfer coefficients around immersed objects in the fluidized bed. Thus, it is not surprising that since the early spreading of the fluidized bed technology a considerable experimental and theoretical activity on this topic has been reported in the literature, mostly… Expand

Figures from this paper

Mass transfer under segregation conditions in fluidized beds
In the present work, mass transfer under segregation conditions in fluidized beds was measured in two cold-model reactors with different shapes. Silica gel particles, representing biomass char, wereExpand
Heat and mass transfer to/from active particles in a fluidized bed—An analysis of the Baskakov-Palchonok correlation
Abstract Heat and mass transfer to or from single active particles surrounded by inert (passive) particles in a fluidized bed has been investigated based on published correlations. Special emphasisExpand
Direct Numerical Simulation of Fluid Flow and Mass Transfer in Particle Clusters
TLDR
An efficient ghost-cell based immersed boundary method is applied to perform direct numerical simulation (DNS) of mass transfer problems in particle clusters and clustering is found to have negative influence on the mass transfer performance. Expand
Determining the mass-related reaction effectiveness factor of large, nonspherical fuel particles for bridging between intrinsic and apparent combustion kinetics
The utilization of challenging solid fuels in the energy industry is urged by environmental requirements. The combustion kinetics of these fuel particles differs markedly from that of pulverizedExpand
A TCD-based technique for experimental study of mass transfer in a gas–solid fluidized bed with liquid injection
Abstract A technique using the measurement of gas phase concentrations for the study of mass transfer in gas–solid fluidized beds has been developed. This method uses thermal conductivity detectorsExpand
Effects of particle shape in mass-diffusion-controlled dissolution process
  • S. Hsu, Ching-Wei Wu
  • Materials Science
  • 2021
Abstract In this study, an axisymmetric, transient model is used to investigate the effects of particle shape in mass-diffusion-controlled dissolution process. Five particle shapes (sphere, cylinder,Expand
A novel approach for integrating concentrated solar energy with biomass thermochemical conversion processes
Concentrated solar energy provides thermal energy that can be utilised for thermochemical conversion of biomass to produce liquid fuel and gases. This creates an efficient and a carbon-free process.Expand
Direct numerical simulation of coupled heat and mass transfer in dense gas-solid flows with surface reactions
  • J. Lu
  • Materials Science
  • 2018
• A submitted manuscript is the version of the article upon submission and before peer-review. There can be important differences between the submitted version and the official published version ofExpand
Large‐eddy simulation model for the effect of gas bubble dissolution on the dynamics of hydrocarbon plume from deep‐water blowout
During a deep-water wellhead blowout incident, the dynamics of the released hydrocarbon plume is strongly affected by the gas dissolution process that weakens the bubble-induced buoyancy for drivingExpand
Integrating rate based models into multi-objective optimisation of process designs using surrogate models
TLDR
A global surrogate model (SUMO) of a RBM was successfully generated to allow its incorporation into a process design & optimisation (PDO) tool which makes use of an evolutionary MOO, showing that kinetic limitations have significant influence on the result already for standard bulk gas chemical components. Expand
...
1
2
...

References

SHOWING 1-10 OF 87 REFERENCES
Heat and Mass Transfer to a Single Particle in Fluidized Bed
Heat and mass transfer to/from a single active particle in bubbling and circulating fluidized beds have been studied with application to fluidized bed combustion. A method of calculation of the heatExpand
Mass transfer from fixed surfaces to gas fluidized beds
Abstract Mass transfer coefficients were measured for the diffusion of water vapor from a saturated porous sphere into various air-fluidized beds of solid particles. Naphthalene diffusion from aExpand
Convective Heat and Mass Transfer Modeling in Gas-Fluidized Beds
This review examines selected mechanistic and empirical models reported in the literature to predict convective heat and mass transfer coefficients in gas-fluidized beds. The role of hydrodynamics inExpand
Mass transfer around freely moving active particles in the dense phase of a gas fluidized bed of inert particles
Abstract The mass transfer coefficient around freely moving active particles under bubbling/slugging fluidized bed conditions was measured in a lab-scale reactor. The technique used for theExpand
MASS TRANSFER RELATIONSHIPS IN FLUIDIZED-BED COMBUSTORS
Abstract It is proposed that the transfer of oxygen from the bulk phase to the surface of a burning carbon particle immersed in a fluidized bed of incombustible particles can be characterized by theExpand
Mass transfer processes around burning char particles in fluidized beds
The detailed modelling of the fluidized bed combustion of coal depends on the elucidation of the mass transfer processes around large active particles in fluidized beds of smaller inert particles.Expand
Mass transfer to large particles in fluidised beds of smaller particles
A theory is proposed for predicting the transfer of a gas through a fluidised bed of small particles to a large particle. It is proposed that non steady-state mass transfer of the gas occurs by twoExpand
Mass transfer in gas-fluidized beds: measurement of actual driving forces
Abstract Concentration profiles of naphthalene vapors were measured in the flow of air through fluidized beds of naphthalene spheres. Seven different sizes of spheres were used in this study andExpand
On the mechanism of mass transfer in heterogeneous systems—in particular in fixed beds, fluidized beds and on bubble trays
Abstract The analysis of the mass transfer in a bundle of parallel capillaries with various diameters shows that within a certain range the achievable changes of the concentration are almostExpand
Gas-to-particle and particle-to-particle heat transfer in fluidized beds of large particles
Abstract Gas-to-particle and interparticle transfer rates were measured, at room temperature, for three different materials, in the range 1 ≤ U / U mf ≤ 3.5 and 0.900 ≤ d p ≤ 2.250 mm by means ofExpand
...
1
2
3
4
5
...