Low voltage ride-through analysis of 2 MW DFIG wind turbine - grid code compliance validations

@article{Seman2008LowVR,
  title={Low voltage ride-through analysis of 2 MW DFIG wind turbine - grid code compliance validations},
  author={Slavomir Seman and Jouko Niiranen and Reijo Virtanen and Jari-Pekka Matsinen},
  journal={2008 IEEE Power and Energy Society General Meeting - Conversion and Delivery of Electrical Energy in the 21st Century},
  year={2008},
  pages={1-6}
}
  • S. Seman, J. Niiranen, +1 author Jari-Pekka Matsinen
  • Published 20 July 2008
  • Engineering
  • 2008 IEEE Power and Energy Society General Meeting - Conversion and Delivery of Electrical Energy in the 21st Century
The transient behavior of the 2 MW wind turbine under a symmetrical 3-phase voltage dip with zero remaining voltage and unsymmetrical phase-to-phase disturbance with 20 % residual voltage is experimentally studied. The results of the voltage dip tests are compared with simulation study. The comparison of the results shows close agreement; therefore validated simulation model is suitable for performing wind turbine voltage dip test simulations without a need to make the site tests. The developed… Expand
Validation of a DFIG wind turbine model submitted to two-phase voltage dips following the Spanish grid code
In a number of countries where large penetration of wind generation has been developed, the increased impact of wind energy generation on power grid operations has led to the development of gridExpand
Implementation of IEC 61400-27-1 Type 3 Model: Performance Analysis under Different Modeling Approaches
TLDR
In this study, the generic Type 3 wind turbine model developed by Standard IEC 61400-27-1 was submitted to two voltage dips and implemented in two simulation tools: MATLAB/Simulink and DIgSILENT-PowerFactory, finding slight differences dependent on the specific features of each simulation software. Expand
Low voltage ride-through testing of wind turbine converters at ABB helps wind turbines meet the requirements of IEC 61400-21 more quickly
The testing of low-voltage, ride-through capability of wind turbine converters recently has been standardized in the 2nd edition of IEC 61400-21. Thus, testing of the converters produced in theExpand
Field Validation of IEC 61400-27-1 Wind Generation Type 3 Model With Plant Power Factor Controller
Generic electrical simulation models of wind power generation have been developed as standards, such as the IEC 61400-27-1, to be used by wind industry, system operators, and academia for powerExpand
Field validation of a standard Type 3 wind turbine model implemented in DIgSILENT-PowerFactory following IEC 61400-27-1 guidelines
TLDR
The validation process of the generic type 3 wind turbine, i.e., the doubly-fed induction generator, is addressed when simulated in one of the leading electric power system analysis software tools: DIgSILENT-PowerFactory. Expand
Wind Turbine Characterization by Voltage Source Converter Based Test Equipment
In countries where wind power has become a relevant part of the total generated electrical power, transmission system operators (TSOs) have included in their Grid Codes specific technicalExpand
STATCOM Model for Integration of Wind Turbine to Grid
In order to reduce the green house gas emission and dependency on conventional energy sources, the utilization of renewable energy sources for electricity generation is increasing day by day. TheExpand
Grid Code Testing of Wind Turbines by Voltage Source Converter Based Test Equipment
Wind energy is expected to play a crucial role in the energy mix in the future society with limited access to fossil fuels. Wind turbines with larger power rating are being installed every year,Expand
Extensive model validation for generic IEC 61400-27-1 wind turbine models
TLDR
The usefulness, practical applicability, accuracy and reliability of Standard IEC 61400-27-1 is demonstrated, and the reasons for differences in the accuracy of the behaviour of the wind turbine topologies considered are analysed. Expand
...
1
2
3
...

References

SHOWING 1-5 OF 5 REFERENCES
Comparison of simulators for variable-speed wind-turbine transient analysis
This paper presents a comparison of three variable-speed wind turbine simulators used for a 2 MW wind turbine short-term transient behaviour study during a symmetrical network disturbance. TheExpand
Transient performance analysis of wind-power induction generators
TLDR
The author’s aim has been to contribute to the humanizing of science by promoting a more positive image of the natural world. Expand
Configuration and method for protecting converter means
  • International patent application WO2004/091085, Oct
  • 2004
Controller for a wound-rotor induction machine