Corpus ID: 53481225

Least costly closed-loop performance diagnosis and plant re-identification

  title={Least costly closed-loop performance diagnosis and plant re-identification},
  author={A. Mesbaha and X. Bomboisb and M. Forgioneb and H. Hjalmarssonc and P. M. J. V. D. Hofd},
Least costly closed-loop performance diagnosis and plant re-identification A. Mesbaha,∗, X. Bomboisb, M. Forgioneb, H. Hjalmarssonc and P.M.J. Van den Hofd Department of Chemical and Biomolecular Engineering, University of California, Berkeley, CA, USA; Laboratoire Ampère UMR CNRS, Ecole Centrale de Lyon, Ecully Cedex, France; The Automatic Control Laboratory, ACCESS Linnaeus Center, School of Electrical Engineering, KTH-Royal Institute of Technology, Stockholm, Sweden; Electrical Engineering… Expand


Least costly identification experiment for control
All approaches to optimal experiment design for control have so far focused on deriving an input signal (or input signal spectrum) that minimizes some control-oriented measure of plant/model mismatchExpand
Determining the state of a process control system: Current trends and future challenges
In many industrial plants, multiple, interconnected control loops are common. Their maintenance and improvement requires detailed controller performance assessment to determine not only whether theyExpand
Actuator fault tolerant multi-controller scheme using set separation based diagnosis
A new FDI principle is proposed which exploits the separation of sets that characterise healthy system operation from sets thatcharacterise transitions from healthy to faulty behaviour to provide pre-checkable conditions for guaranteed fault tolerance of the overall multi-controller scheme. Expand
Closed-loop performance diagnosis for model predictive control systems
The time-varying dynamics of real systems often limit the life-time performance of model predictive control applications. A critical step for cost-effective maintenance of control systems is toExpand
Closed-loop model validation based on the two-model divergence method☆
Abstract This paper is concerned with model validation and detection of parameter changes under closed-loop conditions. Two closed-loop model validation algorithms are developed based on theExpand
Positive invariant sets for fault tolerant multisensor control schemes
Abstract Positive invariance is a common analysis and control design tool for systems affected by constraints and disturbances. The present paper revisits the construction of ∈-approximations ofExpand
Performance Assessment of Control Loops
The main concern of this thesis is to assess control loop performance using minimum variance control by FCOR algorithm in a convenient way by using only routine operating data and comparing theExpand
Robustness analysis tools for an uncertainty set obtained by prediction error identification
The main new technical contribution of this paper is the robust performance result, which shows that the worst case performance achieved over all systems in such an uncertainty region is the solution of a convex optimization problem involving linear matrix inequality constraints. Expand
Survey on data-driven industrial process monitoring and diagnosis
  • S. Qin
  • Engineering, Computer Science
  • Annu. Rev. Control.
  • 2012
A state-of-the-art review of the methods and applications of data-driven fault detection and diagnosis that have been developed over the last two decades are provided to draw attention from the systems and control community and the process control community. Expand
The Self-Validating Actuator
Abstract Correct functioning of actuators is of great importance to industrial processes. Conventional actuators are hampered by their inherent characteristics (including non-linearities) and faultExpand