Interface-derived solid-state viscoelasticity exhibited by nanostructured and microstructured materials containing carbons or ceramics

@article{Chung2019InterfacederivedSV,
  title={Interface-derived solid-state viscoelasticity exhibited by nanostructured and microstructured materials containing carbons or ceramics},
  author={D. D. L. Chung},
  journal={Carbon},
  year={2019}
}
  • D. Chung
  • Published 1 April 2019
  • Materials Science
  • Carbon

Effect of the structure and morphology of carbon nanotubes on the vibration damping characteristics of polymer-based composites

The structure and morphology of the reinforcing material play an important role in the vibration damping characteristics of polymer composites. In this work, multiwalled carbon nanotubes (MWCNTs)

DIELECTRICITY, ELECTRET, PIEZOELECTRET AND PIEZORESISTIVITY DISCOVERED IN EXFOLIATED-GRAPHITE-BASED FLEXIBLE GRAPHITE, WITH COMPARISON WITH ISOTROPIC GRAPHITE

Introduction This paper reports the dielectric, electret, piezoelectret and piezoresistive behavior of flexible graphite (FG), which is a sheet obtained by the compaction of exfoliated graphite in

Carbon-Matrix Composites

  • D. Chung
  • Materials Science, Engineering
    Encyclopedia of Materials: Technical Ceramics and Glasses
  • 2021

References

SHOWING 1-10 OF 203 REFERENCES

Effect of filler geometry on interfacial friction damping in polymer nanocomposites.

TLDR
A comparison of the active sliding area for a representative volume element of the nanotube and the nanoparticle composites highlights the important role played by the filler geometry in controlling energy dissipation in nanocomposite materials.

Viscoelasticity in carbon nanotube composites

TLDR
Direct shear testing of epoxy thin films containing dense packing of multiwalled carbon nanotube fillers and report strong viscoelastic behaviour with up to 1,400% increase in loss factor (damping ratio) of the baseline epoxy, concluding that damping is related to frictional energy dissipation during interfacial sliding at the large, spatially distributed, nanotubes–nanotube interfaces.

Quasistatic and dynamic mechanical characterization of a woven carbon fiber–zinc oxide nanowires–epoxy composite

The ability to engineer the fiber/matrix interface in carbon fiber reinforced polymers (FRPs) can be achieved by introducing a nanophase between the fiber and the matrix, which could

Processing-structure-property relationships of continuous carbon fiber polymer-matrix composites

  • D. Chung
  • Materials Science, Engineering
  • 2017

Effect of pre-strain on interfacial friction damping in carbon nanotube polymer composites.

  • J. SuhrN. Koratkar
  • Materials Science, Engineering
    Journal of nanoscience and nanotechnology
  • 2006
TLDR
Results indicate that application of pre-strain facilitates the activation of interfacial slip at the nanotube-polymer interfaces at relatively low dynamic strain amplitudes.

Nonlinear Viscoelasticity of Two Dimensional Filler Reinforced Rubber Nanocomposites

This chapter describes the effect of two dimensional filler particles on the non-linear viscoelastic properties of elastomer nanocomposites. The distribution of nanosized fillers and the existing

Nonlinear Viscoelasticity in Three Dimensional Filler Reinforced Rubber Composites and Nanocomposites

This chapter describes the influence of three-dimensional nanofillers used in elastomers on the nonlinear viscoelastic properties. In particular, this part focuses and investigates the most important

Strain dependent visco-elastic response of CNFs' reinforced epoxy composites

Recent advances in the production and availability of nanoscale materials has led to a significant interest in the use of nanoscale fillers in order to augment and tailor material performance in
...