Induction curing of encapsulates

@article{Ross2007InductionCO,
  title={Induction curing of encapsulates},
  author={P. Ross},
  journal={2007 Electrical Insulation Conference and Electrical Manufacturing Expo},
  year={2007},
  pages={370-373}
}
The effectiveness of using induction heating for curing encapsulates in the manufacture of stators and armatures is presented. This paper focuses on a comparison of using convection oven heating vs. low frequency induction heating on a typical motor stator. Key characteristics such as time, temperature, and uniformity are analyzed. Low frequency (60 Hz) induction and traditional methods of heating available for encapsulation curing are discussed. The effect of frequency selection on induced… CONTINUE READING

References

Publications referenced by this paper.