• Corpus ID: 212464136

IOT BASED UNDERGROUND CABLE FAULT DETECTOR

@inproceedings{Kumar2017IOTBU,
  title={IOT BASED UNDERGROUND CABLE FAULT DETECTOR},
  author={Dr. L. Ashok Kumar and Mr. K. Vishnu Murthy},
  year={2017}
}
Underground cables are prone to a wide variety of faults due to underground conditions, wear and tear, rodents etc. Diagnosing fault source is difficult and entire cable should be taken out from the ground to check and fix faults. The project work is intended to detect the location of fault in underground cable lines from the base station in km using a PIC16F877A controller. To locate a fault in the cable, the cable must be tested for faults. This prototype uses the simple concept of Ohms law… 

Figures and Tables from this paper

IoT Technology Based Underground Cable Fault Distance Detection System Using ATmega328P Microcontroller
The objective of this paper is to determine the location of fault in underground cable lines from the source station to exact location of fault in any units, here in kilometres. Whenever a fault
Microcontroller-based Cable Fault and Insulation Flaw Detection in Low-Voltage Cables
TLDR
This method is a cheaper and simpler alternative to existing ones for detecting cable insulation flaw by using the principle of a Varley loop to determine the exact distance of the fault in the underground cable up to the accuracy of a meter.
Automatic Cable Fault Distance Locator Using Arduino
TLDR
The aim was to detect the fault location from transmitting or receiving station up to few meters accuracy using an Arduino based kit based on the principle of a Varley loop for underground cable fault detection.
FPGA Based Fault Distance Detection and Positioning of Underground Energy Cable by Using GSM/GPRS
  • G. Tatar, O. Kiliç, S. Bayar
  • Computer Science
    2019 International Symposium on Advanced Electrical and Communication Technologies (ISAECT)
  • 2019
TLDR
This paper proposes the usage of Field Programmable Gate Arrays (FPGA) for fault distance detection and positioning of an underground cable by using GSM/GPRS by using Very High Speed Integrated Circuit Hardware Description Languages.
IOT BASED WATER AND SOIL QUALITY MONITORING SYSTEM
The traditional technique for testing water and soil quality is to accumulate their examples and send to the work to check and break down. This system is tediousand not conservative. The water
A REVIEW OF DIGITAL FORENSIC CHALLENGES IN THE INTERNET OF THINGS (IOT)
TLDR
This paper reviews literature related to forensics in the IoT and analyse the various models that have been proposed and reveals the difficulty in digital evidence extraction in the Internet of Things domain.
IMPLEMENTATION OF IOT IN SMART IRRIGATION SYSTEM USING ARDUINO PROCESSOR
TLDR
In the proposed Irrigation system IoT, the Microcontroller transmits that information on the internet through a network of IoT in the form of wifi module ESP8266 that is attached to it and enhances automated irrigation as the water pump can be switched on or off through information given to the controller.
Methodologies and Challenges of WSN for IoT
TLDR
Various methods to combine WSNs into the IOT are evaluated and a set of challenges are discussed.
Underground Cable Fault Detection and Prevention Using Blynk
TLDR
In this project some sensors are attached to the cable with microcontroller in underground and that sensor shows the fault location accurately, by this the time and human power for searching for fault location is reduced, and more than that the cable from getting fault is prevented.

References

SHOWING 1-10 OF 22 REFERENCES
Technics of locating underground cable faults inside conduits
A cable fault can be defined as any defect, inconsistency, weakness or non-homogeneity that affects the performance of a cable. All faults in underground cables are different and the success of a
Locating underground cable faults: A review and guideline for new development
Occurrences of underground cable faults in the power transmission and distribution system is unavoidable due to several reasons. Long outage of power supply can cause the power distributors and
Real-time expert system for fault location on high voltage underground distribution cables
To ensure minimum loss of system security and revenue it is essential that faults on underground cable systems be located and repaired rapidly. Currently in the UK, the impulse current method is used
A Line to Ground Fault Location Algorithm for Underground Cable System
This paper proposes a line-to-ground fault location algorithm for underground cable system. A feature of the proposed method is a new algorithm based on the analytic research which has not been tried
IOT Based Green House Monitoring System
TLDR
Message Queue Telemetry Transfer protocol was chosen over Constrained Application Protocol and Extensible Messaging and Presence Protocol in the experiment conducted in terms of its light weight transmission, resource consumption and effectively providing the different quality of services to detect the temperature and humidity as well as the gas leaks encountered in a greenhouse environment.
INTERNATIONAL JOURNAL OF ELECTRONICS AND COMMUNICATION ENGINEERING & TECHNOLOGY (IJECET)
TLDR
This study proposes context based adaptive lossless image codec.(CALIC)(12) that addresses the need for efficient methods and tools for implementation of data compression methods in medical applications.
Ayyoub The Internet of Energy: Smart Sensor Networks and Big Data Management for Smart Grid
  • Procedia Computer Science Elsevier,
  • 2015
Review on-IOT Based Smart Healthcare System
  • International Journal of Advanced Research in Engineering and Technology
  • 2017
...
...