GC-MS determination of polycyclic aromatic hydrocarbons evolved from pyrolysis of biomass

@article{Fabbri2010GCMSDO,
  title={GC-MS determination of polycyclic aromatic hydrocarbons evolved from pyrolysis of biomass},
  author={D. Fabbri and Alessio Adamiano and C. Torri},
  journal={Analytical and Bioanalytical Chemistry},
  year={2010},
  volume={397},
  pages={309-317}
}
AbstractA method for the determination of polycyclic aromatic hydrocarbons (PAHs) in liquid pyrolysate of biomass (bio-oil) was developed with attention to greenness along with accuracy. Bio-oil obtained from preparative pyrolysis at 500 °C of poplar wood as representative biomass matrix was dissolved into acetonitrile (ACN). An aliquot of the ACN solution (0.1 mg bio-oil) was added with water (20% v/v) and spiked with perdeuterated standards, then PAHs were extracted with n-hexane and… Expand
Determination of polycyclic aromatic hydrocarbons in biochar and biochar amended soil
Abstract A method for the determination of the 16 USEPA polycyclic aromatic hydrocarbons (PAHs) in biochar and biochar amended soil was developed. Samples were Soxhlet extracted with anExpand
Evaluation of PAH contamination in soil treated with solid by-products from shale pyrolysis
TLDR
Evaluating the concentrations of polycyclic aromatic hydrocarbons in soils to which solid shale materials were added as soil conditioners revealed that the PAHs were derived from petrogenic rather than pyrogenic sources, suggesting that the use of SSMs as soilconditioners should not cause environmental damage. Expand
Appraisal of polycyclic aromatic hydrocarbons (PAHs) in environmental matrices by analytical pyrolysis (Py-GC/MS
Abstract Large number of studies has demonstrated the usefulness of flash pyrolysis in association with GC–MS in releasing diagnostic volatile compounds informing about the complex composition ofExpand
PAH sampling and quantification from woody biomass fast pyrolysis in a pyroprobe reactor with a modified tar sampling system
Abstract The present work focuses on the sampling procedure and quantification of the PAH yield from the fast pyrolysis of waste softwood. In particular, fast pyrolysis experiments were conductedExpand
Liquid phase pyrolysis of wheat straw and poplar in hexadecane solvent
Abstract There is a need for replacement of fuel, especially transportation fuel, obtained from fossil resources by bio-based alternative. The thermochemical conversion is a feasible method toExpand
Solid Phase Micro-extraction – Gas Chromatography–Mass Spectrometry to Characterize Pyrolysis Products from Textiles
ABSTRACT Headspace solid phase micro-extraction gas chromatography–mass spectrometry (HS-SPME GC–MS) was used for identifying thermally labile volatile compounds from cotton, wool, polyester, olefin,Expand
Quantifying the total and bioavailable polycyclic aromatic hydrocarbons and dioxins in biochars.
TLDR
No clear pattern of how strongly PAHs were bound to differentBiochars was found based on the biochars' physicochemical properties, and total concentrations were below existing environmental quality standards for concentrations of PAhs in soils. Expand
Consequence of replacing nitrogen with carbon dioxide as atmosphere on suppressing the formation of polycyclic aromatic hydrocarbons in catalytic pyrolysis of sawdust.
TLDR
This study indicates the practical application of CO2 as an atmosphere in catalytic pyrolysis to improve the bio-oil quality by suppressing PAHs formation and adjusting compound constituent. Expand
Bio-oils from biomass slow pyrolysis: a chemical and toxicological screening.
TLDR
The approach outlined allows the collection of screening information on the potential hazards posed by the bio-oils and can be particularly useful when limited time and analytical resources reduce the possibility to obtain detailed specific experimental data. Expand
One step thermal conversion of lignin to the gasoline range liquid products by using zeolites as additives
One step thermal conversion of lignin to gasoline range liquid products was accomplished by pyrolyzing softwood (SW) kraft lignin with select zeolites at 600 °C. Gel Permeation Chromatography (GPC)Expand
...
1
2
3
4
...

References

SHOWING 1-10 OF 29 REFERENCES
Evaluating emission levels of polycyclic aromatic hydrocarbons from organic materials by analytical pyrolysis
Abstract A procedure in off-line analytical pyrolysis was investigated for the rapid determination of polycyclic aromatic hydrocarbons (PAHs) evolved from thermal degradation of organic materials.Expand
Polycyclic aromatic hydrocarbons (PAHs) in bio-crudes from induction-heating pyrolysis of biomass wastes.
TLDR
The quantitative analysis of 21 priority pollutant polycyclic aromatic hydrocarbons (PAHs) in bio-crudes examined using gas chromatography/mass spectrometry (GC/MS) revealed that the PAHs inBio-crude were primarily dominant in the low molecular weight (LMW) PAHS. Expand
Analysis of Polycyclic Aromatic Hydrocarbons Formed During Off-Line Pyrolysis of Ergosterol by GC–MS–SIM
The formation of polycyclic aromatic hydrocarbons (PAHs) during pyrolysis of ergosterol at 700 and 900 °C is investigated. The pyrolysis is carried out in a furnace-type pyrolyzer with an off-lineExpand
Analysis of aromatic hydrocarbons in pyrolytic oil derived from biomass
Abstract The pyrolysis of biomass is receiving increasing attention since potentially all of the product streams have a valuable end use. The derived pyrolytic oils are chemically very complex andExpand
Effect of pyrolysis conditions on the formation of polycyclic aromatic hydrocarbons (PAHs) from polyphenolic compounds
Abstract Effect of pyrolysis conditions, such as temperature and substrate composition, i.e. inorganics, on the formation of polycyclic aromatic hydrocarbons (PAHs) from polyphenolic compounds,Expand
Low temperature mechanism for the formation of polycyclic aromatic hydrocarbons from the pyrolysis of cellulose
Abstract The formation of polycyclic aromatic hydrocarbons (PAHs) from the pyrolysis of cellulose over the temperature range of 300–650 °C has been investigated. Detectable amounts (microgram perExpand
Influence of temperature on the products from the flash pyrolysis of biomass
Biomass in the form of mixed wood waste was pyrolysed in a fluidized bed reactor at 400, 450, 500 and 550°C. The char, liquid and gas products were analysed to determine their elemental compositionExpand
Application of off-line pyrolysis with dynamic solid-phase microextraction to the GC–MS analysis of biomass pyrolysis products
Abstract Pyrolysis coupled with dynamic solid-phase micro extraction (Py-SPME) followed by GC–MS analysis was applied to the determination of volatile compounds evolved by a micro-scale off-lineExpand
Polynuclear aromatic hydrocarbons in fly ash from pressurized fluidized bed gasification of fuel blends. A discussion of the contribution of textile to PAHs
The identification and quantification of 20 different polynuclear aromatic hydrocarbons (PAHs) in the fly ash from a pressurized fluidized bed (PFB) air gasification system based:on hot gas filteringExpand
Evaluation of polycyclic aromatic hydrocarbons in gasoline by HPLC and GC-MS
SummaryIn this paper the evaluation of polycyclic aromatic hydrocarbons (PAHs) in gasoline is described. A procedure involving a double extraction of samples with N-methylpirrolidone-water-phosphoricExpand
...
1
2
3
...