Corpus ID: 209505855

Fluoride Release from Different Powder Liquid Ratios of Fuji VII

  title={Fluoride Release from Different Powder Liquid Ratios of Fuji VII},
  author={W. Prapansilp and P. Rirattanapong and R. Surarit and K. Vongsavan},
Introduction: The quantity of fluoride ions released from glass-ionomer cements is of major importance in the prevention of dental caries in children. Fuji VII is a glass-ionomer that releases more fluoride ions than other fluoride releasing materials. Purpose: To evaluate the concentration of fluoride ions released from the Fuji VII with differing powder liquid (P/L) mixing ratios. Methods: Eight cylindrical specimens from four groups with different P/L ratios were prepared and immersed… Expand

Figures and Tables from this paper


Fluoride Release by Glass Ionomer Cements, Compomer and Giomer
Fuji IX, Fuji VII, Fuji IX Extra, and Fuji II LC released higher amounts of fluoride compared to Beautifil and Dyract Extra in this study, suggesting that the extent of the glass ionomer matrix plays an important role in determining the fluoride releasing ability of glass ionomers cement materials. Expand
Effect of Powder/Liquid Ratio on Fluoride Release of Glass Ionomers
Objective: Evidence shows that the powder/liquid mixing ratio recommended by the manufacturers is often not respected when mixing the glass ionomer (GI) powder and liquid, yielding a GI cement withExpand
Estimation of Fluoride Release from Various Dental Materials in Different Media—An In Vitro Study
It can be concluded that pH strongly affects fluoride release from dental restorative materials as seen in pH cycling model for all the materials followed by deionized water and artificial saliva in decreasing order. Expand
Fluoride content and recharge ability of five glassionomer dental materials
The tested materials could be considered as promising dental materials with potential prophylactic characteristics due to their relatively high fluoride content, but also the ability to extensively reabsorb fluoride ions, especially in acidic environments. Expand
Resin-modified glass ionomer cements: fluoride release and uptake.
  • L. Forsten
  • Materials Science, Medicine
  • Acta odontologica Scandinavica
  • 1995
Thin consistency of a mix resulted in higher fluoride release for one resin-modified material than a thick mix, and low pH increased the fluorideRelease for all materials. Expand
Fluoride Release and Recharge from Different Materials Used as Fissure Sealants
Within the limitations of this short-term study, glass ionomer-based sealants were shown to have higher initial fluoride release as well as higher fluoride recharge capacity than other sealants. Expand
Fluoride release from glass-ionomer cements, compomers and resin composites.
The link between fluoride release and an acid-base reaction seems to be confirmed and the glass-ionomer composition (glass particles and polyacid's type, powder/liquid ratio) should have more influence on fluoride release than material type. Expand
A comparison of fluoride release from four glass-ionomer cements.
Fluoride release from three glass-ionomer cements and one cement was measured over 1 year and compared, finding that low powder-liquid ratios always lead to more fluoride release than high ratios. Expand
Fluoride release from glass ionomers used as luting agents.
The significant release of fluoride indicated that glass-ionomer cements could be effective in reducing caries. Expand
Review on fluoride-releasing restorative materials--fluoride release and uptake characteristics, antibacterial activity and influence on caries formation.
It is not proven by prospective clinical studies whether the incidence of secondary caries can be significantly reduced by the fluoride release of restorative materials, but fluoride-releasing materials, predominantly glass-ionomers and compomers, did show cariostatic properties and may affect bacterial metabolism under simulated cariogenic conditions in vitro. Expand