Fault analysis using PSCAD/EMTDC for 150 kV South Sulawesi transmission system

Abstract

Short circuit fault as one of the characteristics of transient disturbances in electric power systems that must be addressed by the safety equipment. The increase at occurrence of short circuit generates large electrical currents and at a very low voltage. This research will address the simulation of short circuit interruption in the 150 kV transmission line system. The method is used to perform the simulation with the help of PSCAD / EMTDC and PWS (Power World Simulator) software's to obtain the characteristic of current and voltage on the 150 kV transmission network system in South Sulawesi. This discussion aims to examine the changes in current and voltage during short circuit fault with or without fault impedance and fault location distance. In this case, it will be taken case of short circuit between the air ducts with Bus PKEP to PPARE, For a distance fault of 22.5 km obtained by the fault current from the bus PKEP biggest, while at a distance of 66.5 km is acquired the fault current of the largest from the bus PPARE, of four types of errors are analyzed on the Z = 0 ohm is the largest short circuit interruption occurs in three phase fault (LLL), while at Z = 10 ohm = 15 ohm Z of the biggest mistakes of the line shortcircuit line to ground faults (LLG).

14 Figures and Tables

Cite this paper

@article{Saini2012FaultAU, title={Fault analysis using PSCAD/EMTDC for 150 kV South Sulawesi transmission system}, author={Mohan Lal Saini and A. A. Mohd Zin and M. W. Mustafa and Ahmad Rizal Sultan}, journal={2012 IEEE Symposium on Industrial Electronics and Applications}, year={2012}, pages={141-146} }