Fault-Induced Transient Analysis for Real-Time Fault Detection and Location in Transmission Lines
@inproceedings{Costa2011FaultInducedTA, title={Fault-Induced Transient Analysis for Real-Time Fault Detection and Location in Transmission Lines}, author={Fl{\'a}vio Bezerra Costa and Benemar Alencar Souza}, year={2011} }
The real-time detection of the fault-induced tran- sients on both transmission line terminals can allow the direc- tional protection system to detect and locate faults in agreement with a high-speed fault clearance. This paper presents a wavelet- based method for real-time detection of the fault-induced tran- sients. The method can detect whether the fault is within the protected line and estimate the fault location through a commu- nication link at both line terminals. The wavelet coefficients…
Figures and Tables from this paper
19 Citations
The Effects of the Fault Inception Angle in Fault-Induced Transients on Series Compensated and Non-Compensated Transmission Lines
- Engineering
- 2013
The fault-induced transient analysis is an important tool for high-speed fault detection, classification, and location. Therefore, the assessment of the effects of fault parameters such as fault…
Fault-induced transient detection based on real-time analysis of the wavelet coefficient energy
- Engineering2014 IEEE PES T&D Conference and Exposition
- 2014
This paper presents a novel wavelet-based methodology for real-time detection of fault-induced transients in transmission lines, where the wavelet coefficient energy takes into account the border effects of the sliding windows, and the performance of the proposed energy analysis is not affected by the choice of the mother wavelet.
The effects of the mother wavelet for transmission line fault detection and classification
- EngineeringProceedings of the 2011 3rd International Youth Conference on Energetics (IYCE)
- 2011
The analysis of fault-induced transients can provide extensive information about the fault type, detection, location, direction, and sustained time. Voltages and currents with fault-induced…
Boundary Wavelet Coefficients for Real-Time Detection of Transients Induced by Faults and Power-Quality Disturbances
- EngineeringIEEE Transactions on Power Delivery
- 2014
In the last few years, much research has been focused on wavelet coefficients for high-speed detection of transients induced by faults, high impedance faults (HIFs), and some power-quality (PQ)…
Comparison between two versions of the discrete wavelet transform for real-time transient detection on synchronous machine terminals
- Engineering2012 10th IEEE/IAS International Conference on Industry Applications
- 2012
The wavelet transform is a powerful tool for real-time detection of transients on synchronous machine terminals which can be used into the control strategy of a power system stabilizer in order to…
A TDQ-based fault detector for digital power system relaying
- Engineering2014 IEEE PES General Meeting | Conference & Exposition
- 2014
In this paper, a fault detector (FD) based on Park's transformation (TDQ) for digital power system relaying application is presented. It detects faults by identifying decaying DC components and phase…
Wavelet-based fault detection in grid-connected photovoltaic systems
- Engineering2013 Brazilian Power Electronics Conference
- 2013
This paper proposes a real-time wavelet-based fault detection as well as a real-time analysis of voltage sag/swell due to faults in a grid-connected photovoltaic system, which is the first step for a…
Influence of Coupling Capacitor Voltage Transformers on Travelling Wave-Based Fault
- Engineering
- 2015
The coupling capacitor voltage transformer (CCVT) performance is quite acceptable during steady-state, but it is far from ideal when the power system is subjected to short-circuits conditions. In…
Benefits of CCVT secondary voltage compensation on traveling wave-based fault locators
- Engineering2014 IEEE PES General Meeting | Conference & Exposition
- 2014
In this paper, the influence of the frequency response of coupling capacitor voltage transformers (CCVT) on traveling wave-based fault locators is analyzed, highlighting the benefits of the CCVT…
HIGH TRANSIENT BASED TRANSMISSION LINE PROTECTION TECHNIQUES
- Engineering
- 2017
This paper presents the application of 'Transient Based Protection' techniques in power transmission lines. A brief introduction to the history of development of relaying principles for transmission…
References
SHOWING 1-10 OF 21 REFERENCES
Positional protection of transmission line using fault generated high frequency transient signals
- Engineering
- 2000
This paper presents a new technique for high-speed protection of transmission lines, the positional protection technique. The technique uses a fault transient detector unit at the relaying point to…
Transient Positional Protection of Transmission Lines Using Complex Wavelet Analysis
- EngineeringIEEE Power Engineering Review
- 2002
This paper presents a new high-speed protection scheme, transient positional protection (TPP) for power transmission lines. This scheme is developed using complex wavelet analysis, based on the…
Fault detection and classification in transmission lines based on wavelet transform and ANN
- EngineeringIEEE Transactions on Power Delivery
- 2006
This paper proposes a novel method for transmission-line fault detection and classification using oscillographic data. The fault detection and its clearing time are determined based on a set of rules…
Detection and Classification of Transient Disturbances in Power Systems
- Engineering
- 2010
This paper presents a wavelet-based method for transient disturbance analysis in oscillographic records of the transmission power systems. The proposed method can recognize faults and other…
Fault classification based on wavelet transforms
- Engineering, Computer Science2001 IEEE/PES Transmission and Distribution Conference and Exposition. Developing New Perspectives (Cat. No.01CH37294)
- 2001
The paper presents the basics of the wavelet transforms technique in power systems terminology and illustrates its use in the new algorithm, showing that the proposed algorithm offers a fast and secure technique for fault classification inPower systems.
A wavelet-based procedure for automatically determining the beginning and end of transmission system voltage sags
- EngineeringIEEE Power Engineering Society. 1999 Winter Meeting (Cat. No.99CH36233)
- 1999
Voltage sag disturbances are characterized by several parameters, including but not limited to sag duration and depth. An accurate determination of fault inception and clearing times is needed to…
The Spectra of Fault-Induced Transients
- EngineeringIEEE Transactions on Power Apparatus and Systems
- 1979
During the first cycle or two following a power system fault, a high-speed protective relay is expected to make a decision as to the severity or location of the fault, usually based on 60 Hz…
Non-unit protection technique for EHV transmission systems based on fault-generated noise. Part 1: signal measurement
- Computer Science
- 1994
The paper describes the signal processing techniques developed for a new protection technique for EHV transmission lines that utilises fault-generated high-frequency signals derived from the signal measurement circuit to determine whether the fault is internal or external to the protected zone.
Detection and classification of high frequency transients using wavelet analysis
- EngineeringIEEE Power Engineering Society Summer Meeting,
- 2002
This paper assesses the use of wavelet analysis to detect and classify high frequency transients. Work within the field of wavelet analysis is reviewed and the applications within the field of power…