• Corpus ID: 14199391

Extra losses caused in high current conductors by skin and proximity effects

@inproceedings{Ducluzaux2003ExtraLC,
  title={Extra losses caused in high current conductors by skin and proximity effects},
  author={Andr{\'e} Ducluzaux},
  year={2003}
}
Collection Technique "Cahiers Techniques" is a collection of documents intended for engineers and technicians, people in the industry who are looking for more in-depth information in order to complement that given in product catalogues. Furthermore, these "Cahiers Techniques" are often considered as helpful "tools" for training courses. They provide knowledge on new technical and technological developments in the electrotechnical field and electronics. They also provide better understanding of… 
Analysis and application of transmission line conductors
Skin effect is usually a concern reserved for radio frequency design and for high current conductors used in utility power distribution. Proximity effect between adjacent conductors has traditionally
Practical Aspects of the Skin Effect in Low Frequencies in Rectangular Conductors
TLDR
An analysis of the behavior of the current density distribution over the cross-section of differently combined rectangular conductors subject to power frequency current and the influence of a correlated effect that is the proximity effect shows itself as being predominant, which allow bridging the knowledge gap in this theme.
NUMERICAL METHOD OF COMPUTING IMPEDANCES IN SHIELDED AND UNSHIELDED THREE-PHASE RECTANGULAR BUSBAR SYSTEMS
In this paper, a new numerical method of calculating rectangular busbar impedance is proposed. This method is based on integral equation method and partial inductance theory. In particular,
Development of high-capacity substation connectors compatible with htls technology
The advent of HTLS (High Temperature, Low Sag) conductors imposes more severe operating conditions on devices such as substation connectors intended for transmission and distribution systems, which
System dependant IDMT settings: direct buried underground cable
TLDR
This research project develops and implements a simulation model using finite element analysis that analyses specific underground cable systems based on operating and environmental conditions and outlines the effect that environmental conditions have on the required protection settings of underground cable system.
Comparative Analysis of Electrical Parameters for Three Phase Busbar Trunking System
Busbar Trunking system is one of the most widely used in electrical power distribution in place of cable. The major reasons behind the popularity of the BBT is flexibility in design, on-site
Thermal Analysis of Dry-Type Air-Core Coils for the Optimization of Passive Filtering Systems
The analysis of harmonic currents in distribution networks of industrial facilities and the associated filtering stages is essential to optimize the production of these installations. Dry-type
Electromagnetic flyer plate technology and development of a novel current distribution sensor
The development of both experimental and diagnostic equipment to assist with simulating the mechanical effects of cold X-ray deposition is covered by this work. This thesis reviews the various
Computationally-Efficient, Generalized Expressions for the Proximity-Effect in Multi-Layer, Multi-Turn Tubular Coils for Wireless Power Transfer Systems
TLDR
A new method, based on the Fourier series, for evaluating proximity-effect losses in a multi-turn, multi-layer tubular coil is presented, which can be incorporated into the design and optimization procedures.
Optimization of short-circuit tests based on finite element analysis
TLDR
This paper analyzes a simple method to minimize the power requirements when conducting short-circuit tests, based on the reduction of reactive power consumption during the test, which is based on placing a wired conductor forming a closed inner loop concentric with the testing loop.
...
...

References

SHOWING 1-10 OF 39 REFERENCES
Standard Handbook for Electrical Engineers
  • A. R.
  • Engineering
    Nature
  • 1923
WE think that the volume under notice justifies its title as being a “standard” handbook. The general make-up and arrangement leave little to be desired. The whole field of electrical engineering is
Skin Effect in Tubular and Flat Conductors
  • H. B. Dwight
  • Physics
    Transactions of the American Institute of Electrical Engineers
  • 1918
A method is presented for calculating the skin effect resistance ratio of a tube, which is a form of conductor to be recommended for high-frequency work. A formula is also developed by means of which
Some Proximity Effect Formulas for Bus Enclosures
Proximity effect currents, caused by parallel conductors in proximity with each other, are important chiefly because of the increase in resistance loss that they cause. Large, nonmagnetic tubular
Current distribution in a rectangular conductor
  • J. Daley
  • Physics
    Electrical Engineering
  • 1939
The extensive use of rectangular conductors for large alternating currents has made the determination of their electrical characteristics a problem of practical importance. Although these conductors
Skin effect in rectangular conductors
IN THE DESIGN of bus bars for generating stations and substations, particularly of the isolated-phase type, there is need for more complete information on the skin effect, at commercial frequencies,
Magnetic Field Distribution in Solid Metallic Structures in the Vicinity of Current Carrying Conductors, and Associated Eddy-Current Losses
The analysis of the magnetic field distribution in conducting slabs in the presence of current carrying conductors and the calculation of eddy-current losses is presented. Integral expressions of
AC Resistance and Reactance of Isolated Rectangular Conductors
The recently proposed normal mode theory of current flow in straight, long conductors is applied to nonmagnetic, isolated, rectangular bars of various side ratios. Sufficient modal parameters have
Proximity Effect in Wires and Thin Tubes
  • H. B. Dwight
  • Physics
    Transactions of the American Institute of Electrical Engineers
  • 1923
Formulas are given, with examples, for the following new problems in proximity effect resistance ratio: Thin Tube and Infinitesimal Wire; Two Thin Tubes in Return Circuit; Two Thin Tubes in Parallel;
Induced Currents in High-Capacity Bus Enclosures
  • S. C. Killian
  • Physics
    Transactions of the American Institute of Electrical Engineers
  • 1950
IN RECENT YEARS the air-insulated metal-enclosed high-capacity bus has come into wide use in central stations. These busses are built in a variety of designs with three basic configurations:
Mathematics and physics
The major in Mathematics and Physics allows students to explore the productive interaction between the two subjects more extensively than either individual major. Prerequisites to the major include
...
...