• Engineering
  • Published 2010

Effect of bending on formability limits

@inproceedings{Lpez2010EffectOB,
  title={Effect of bending on formability limits},
  author={Alejandro Mart{\'i}nez L{\'o}pez and A. H. Boogaard},
  year={2010}
}
In order to fulfill new environmental regulations to reduce Greenhouse Gas Emissions (GHG), new grades of Advanced High-Strength Steel (AHSS) have been replacing conventional steels in vehicle’s body structures. These changes are intended to reduce the estimated total weight, and increase fuel efficiency of vehicles. Although, the implementation of these materials brought new challenges to predict the material response under sheet metal operations. One of the techniques widely used to… CONTINUE READING

References

Publications referenced by this paper.
SHOWING 1-10 OF 14 REFERENCES

Effect of Bending on Formability Limits - A Brief Review

A. Martinez-Lopez
  • M2i Internal Report Project No. M22.1.09335,
  • 2010

Influence of Curvature on the Forming Limit Curve

E. Fictorie
  • Master thesis,
  • 2009

An Analysis of sheet necking under combined stretching and bending

N. E. de Kuijf
  • Master Thesis, Eindhoven University of Technology,
  • 2008

C.H.L.J., “FLC simulations using PAMStamp, the effect of friction coefficient and the rubber disc

ten Horn
  • Corus RD&T IJmuiden, Refsource:
  • 2008

Garcia-Lomas: On the study of the effect of bending in the formability of metal sheets

C. Vallellano, F.J.D. Morales
  • Numisheet 2008 Interlaken Switzerland
  • 2008

Larour: On an exceptional forming behaviour aspect of AHSS sheets

E. T. Till, P. E. Berger
  • IDDRG 2008 Olofström Sweden,
  • 2008

FLCs: are we at a turn?

A. Col
  • IDDRG Conference,
  • 2005