Development of a novel compression tester and rheo-mechanical properties of wet-mass powder. II--Effect of moisture content on the rheo-mechanical properties.

@article{Watano2003DevelopmentOA,
  title={Development of a novel compression tester and rheo-mechanical properties of wet-mass powder. II--Effect of moisture content on the rheo-mechanical properties.},
  author={Satoru Watano and Tomoko Yoshikawa and Yoshifumi Osako and Masamitsu Tsuhari},
  journal={Chemical \& pharmaceutical bulletin},
  year={2003},
  volume={51 7},
  pages={
          751-3
        }
}
In our previous paper [Watano S., et al., Chem. Pharm. Bull., 51(7), 747-750 (2003)], a novel compression tester, which enables the vertical and radial pressure transmission measurement, has been developed and quantitative analysis of rheo-mechanical properties of wet-mass powder prepared by different kneading times was conducted. In this study, the compression test was conducted by using the kneaded wet-mass powders prepared by different moisture contents. Pressure transmission characteristics… 
5 Citations

Figures from this paper

Scale-up of wet kneading in a novel vertical high shear kneader.
TLDR
Scale-up of wet kneading in the novel vertical high shear kneader found that the properties of the dried pellets and their scale-up characteristics were well expressed by an agitation power per unit vessel volume and dimensionless Froude number.
Prediction of granule physical property by a novel compression energy of wet powder.
TLDR
It was concluded that the compression energy of the wet powder could be used for the formulation study and the process control of wet granulation.
Determination of optimal formulation for extrusion granulation by compression test of wet kneaded mass.
TLDR
It was found that addition of a binder (HPC-L) to pharmaceutical powders lowered the load of a high-compressing type extruder, since the binder reduced the friction among the wet mass during extrusion.
Compression physics in the formulation development of tablets.
TLDR
Various properties of drugs and excipients, such as moisture content, particle size and distribution, polymorphism, amorphism, crystal habit, hydration state, and lubricant and binder level of the blend that have an influence on compaction are discussed.

References

SHOWING 1-10 OF 11 REFERENCES
Quantitative analysis of water dispersion conditions and pressure transmission characteristics of a wet kneaded mass.
TLDR
It can be concluded that the developed compaction tester can quantitatively evaluate the water dispersion condition of a wet kneaded mass and also predict properties of the final extruded products.
The effect of die materials and pressure-dependent slip on the extrusion of linear low-density polyethylene
The flow of linear low-density polyethylene through stainless-steel slit dies occurred at shear rates approximately 12% higher than in identical α-brass dies at the same wall shear stresses,
Heat transfer and the mechanism of drying in agitation fluidized bed
This paper describes experimental and numerical analyses on the heat transfer between air and particles in an agitation fluidezed bed drying process. Spherical particles made of crystalline cellulose
Analysis of Pressure Drop in Extruder Dies
Entrance pressure drop of extruder dies increased with a decrease in the ratio of barrel-to-die diameter during the extrusion of corn. For the low Reynolds number flow studied (1.77 x 10−3≤ Re ≤ 9 x
The effect of particle size on the rheological properties of ceramic paste
Etude par viscosimetrie capillaire de deux pâtes de α−Al 2 O 3 a base de particules submicroniques
Granulation, new techniques.
  • H. Leuenberger
  • Materials Science, Medicine
    Pharmaceutica acta Helvetiae
  • 1982
...
...