Design of Windmill Power Generation Using Multi-Generator and Single Rotor (Horizontal Blade)
@article{Velan2012DesignOW, title={Design of Windmill Power Generation Using Multi-Generator and Single Rotor (Horizontal Blade)}, author={S. S. Velan}, journal={Innovative Systems Design and Engineering}, year={2012}, volume={3}, pages={39-51} }
Wind energy is the environmental free and one of the best renewable energy for generation of electric power. The main aim of the paper is “to produce current using multi generator and single rotor”. This paper proposes multi-generator to address potential challenges: dimension, cost and reliability. The two permanent magnet D.C. generators are desired to share the single shaft through straight bevel gears. These poles of the two generators will be changed as alternate to parallel. This paper… CONTINUE READING
References
SHOWING 1-10 OF 13 REFERENCES
Variable speed wind turbine based on multiple generators drive-train configuration
- Computer Science
- 2010 IEEE PES Innovative Smart Grid Technologies Conference Europe (ISGT Europe)
- 2010
- 3
- PDF
design data book of engineering
- Faculty of mechanical engineering
- 2011
wind turbine based on multiple generators drive-train configuration, E-ISBN: 978-1-4244-8509-3
- Print ISBN:
- 2010
wind electrical system
- 2005
wind electrical system, New Delhi: oxford university press, ISBN
- ISBN –
- 2005
Mechanical Engineering Design, Sixth Edition
- Tata Mcgraw – Hill,
- 2003
Ugural A. C., Mechanical Design An Integrated Approach
- Mechanical Engineering Design
- 2003
Transverse module, M T = 5 mm No. of teeth
- Z 1 =
- 1994