DC Distributed Power Systems - Analysis, Design and Control for a Renewable Energy System
@inproceedings{Karlsson2002DCDP,
title={DC Distributed Power Systems - Analysis, Design and Control for a Renewable Energy System},
author={Per Karlsson},
year={2002}
}Renewable energy systems are likely to become wide spread in the future due to environmental demands. As a consequence of the dispersed nature of renewable energy systems, this implies that there will be a distributed generation of electric power. Since most of the distributed electrical energy sources do not provide their electric power at line frequency and voltage, a DC bus is a useful common connection for several such sources. Due to the differences in output voltage among the sources…
Figures and Tables from this paper
figure 2.1 
figure 2.10 
figure 2.11 
figure 2.12 
figure 2.2 
figure 2.3 
figure 2.4 
figure 2.5 
figure 2.6 
figure 2.7 
figure 2.8 
figure 2.9 
figure 3.1 
table 3.1 
figure 3.10 
figure 3.11 
figure 3.12 
figure 3.13 
figure 3.14 
figure 3.15 
figure 3.16 
figure 3.17 
figure 3.18 
figure 3.19 
figure 3.2 
figure 3.4 
figure 3.5 
figure 3.6 
figure 3.8 
figure 3.9 
figure 4.1 
table 4.1 
figure 4.10 
figure 4.11 
figure 4.12 
figure 4.3 
figure 4.4 
figure 4.5 
figure 4.6 
figure 4.7 
figure 4.8 
figure 4.9 
figure 5.1 
figure 5.10 
figure 5.11 
figure 5.12 
figure 5.13 
figure 5.2 
figure 5.3 
figure 5.4 
figure 5.5 
figure 5.6 
figure 5.7 
figure 5.8 
figure 5.9 
figure 6.1 
table 6.1 
figure 6.11 
figure 6.12 
figure 6.13 
figure 6.14 
figure 6.15 
figure 6.16 
figure 6.17 
figure 6.2 
table 6.2 
figure 6.3 
figure 6.4 
figure 6.5 
figure 6.6 
figure 6.8 
figure 6.9 
table 7.1 
figure 7.10 
figure 7.11 
figure 7.12 
figure 7.13 
figure 7.14 
figure 7.15 
figure 7.16 
figure 7.17 
table 7.2 
figure 7.2 
figure 7.3 
figure 7.4 
figure 7.5 
figure 7.6 
figure 7.7 
figure 7.8 
figure 7.9 
figure A.1 
table A.1 
figure A.2 
table A.2 
figure A.3 
table A.3 
figure A.4 
table A.4 
figure A.5 
table A.5 
figure A.6 
figure A.7 
figure A.9 
figure C.1 
table C.1 
figure C.2
78 Citations
A practical solution for grid connected dispersed generation from renewable sources: DC connection
- EngineeringInternational Symposium on Power Electronics, Electrical Drives, Automation and Motion, 2006. SPEEDAM 2006.
- 2006
The exploitation of renewable sources is expected to become the most promising solution to the environmental issues and to the permanent increase of prices of the fossil energy. Since most of…
High-power medium-voltage DC-DC converters : design, control and demonstration
- Engineering
- 2017
In the last years, power generation from renewable energy sources has increased steadily. On the one hand, this enables the independence from fossil fuels and the potential for decreasing…
Operation and Control-Oriented Modeling of a Power Converter for Current Balancing and Stability Improvement of DC Active Distribution Networks
- EngineeringIEEE Transactions on Power Electronics
- 2011
Future active distribution networks appear as a solution to the energy distribution challenges. In this context, dc systems show potential for reducing losses and electronic equipment costs. Power…
High Speed Differential Smart DC Distribution System
- Engineering
- 2016
In day to day life electrical energy has evolved as one of the most basic needs of human being. As we know that electricity generated at generating station will be transferred to required location…
Protection and fault management in active distribution systems
- Engineering
- 2016
The integration of renewable energy resources (RES), as a type of distributed generation (OG) units, is increasing in distribution, systems. This integration, changes the topology, performance and…
The Load as an Energy Asset in a Distributed DC SmartGrid Architecture
- EngineeringIEEE Transactions on Smart Grid
- 2012
It is necessary to model and control a microgrid as a system of systems that share some common aspects, such as voltage levels, but can operate independently, using local information in the form of the bus voltage, which improves system reliability.
Design of a Three-Phase Series Resonant Converter for Offshore DC Grids
- Engineering2007 IEEE Industry Applications Annual Meeting
- 2007
The Series Resonant Converter, which will be discussed in this paper offers a possible solution that is efficient and cost effective for the electrification of large scale wind farms.
Power Electronics and Wind Power
- Engineering, Environmental Science
- 2003
Renewable energy facilities will constitute a major contribution to electrical power in the future. The wind turbine will, together with biomass, form the major renewables parts up to year 2030…
Design and control of a DC collection grid for a wind farm
- Engineering, Physics
- 2009
In this thesis, the internal DC collection grid for a wind farm is investigated regarding the design, losses and dynamic operation for both normal operating conditions and for different fault…
References
SHOWING 1-10 OF 75 REFERENCES
DC bus voltage control for a distributed power system
- Engineering
- 2003
This paper addresses voltage control of distributed DC power systems. DC power systems have been discussed as a result of the introduction of renewable, small-scale power generation units. Also,…
An active bus conditioner for a distributed power system
- Engineering30th Annual IEEE Power Electronics Specialists Conference. Record. (Cat. No.99CH36321)
- 1999
In a distributed power system with many power converters on the DC bus, there is always the concern of the possible interactions between the system building blocks, which are designed at the…
The market for distributed power systems
- Engineering[Proceedings] APEC '91: Sixth Annual Applied Power Electronics Conference and Exhibition
- 1991
Distributed power architectures replace central power sources with one bulk power supply that is converted to the required voltages by DC/DC power converters at the point of need. The benefits and…
A detailed R-L fed bridge converter model for power flow studies in industrial AC/DC power systems
- EngineeringIEEE Trans. Ind. Electron.
- 1995
A coal mine power system and a DC electrified transit railway system with regenerative braking function, a part of Taipei Rapid Transit Systems under planning, have been analyzed to show the improved accuracy and good convergence characteristics of the developed Newton-Raphson power flow formulation with the proposed converter model.
Simulation of DC power distribution systems
- Engineering, PhysicsProceedings of Industrial and Commercial Power Systems Conference
- 1994
Direct current (DC) power distribution systems have been extensively used in nuclear power plants and transit systems. The major concern of DC system studies is the voltage and voltage drop at load…
Quasi Resonant DC Link Converters - Analysis and Design for a Battery Charger Application
- Engineering
- 1999
Environmental aspects have during the last years made electric vehicles an interesting competitor to the present internal combustion engine driven vehicles. For a broad introduction of pure electric…
Power Control Applications on a Superconducting LVdc Mesh
- PhysicsIEEE Power Engineering Review
- 1991
The behavior of a high-current, low-voltage DC system is studied. The DC system is made up of superconducting cables connected in a meshed configuration. The system could be made up of several large…
An LVDC industrial power distribution system without central control unit
- Engineering2000 IEEE 31st Annual Power Electronics Specialists Conference. Conference Proceedings (Cat. No.00CH37018)
- 2000
This paper develops a scheme to control a parallel connected, multiterminal DC power distribution system without the need of central control unit for fast communication. The described scheme utilizes…
DC distribution for industrial systems: opportunities and challenges
- EngineeringIEEE Technical Conference Industrial and Commerical Power Systems
- 2002
This paper investigates the opportunities and challenges associated with adopting a DC distribution scheme for industrial power systems. A prototype DC distribution system has been simulated to…
Incorporation of a SMES coil into a superconducting LVdc transmission system
- PhysicsIEEE Transactions on Applied Superconductivity
- 1997
The performance of a superconducting low voltage direct current (LVdc) transmission system can be significantly enhanced through the addition of a superconducting magnetic energy storage (SMES) coil.…