Atomic weights of the elements 2005 (IUPAC Technical Report)

@article{Wieser2006AtomicWO,
  title={Atomic weights of the elements 2005 (IUPAC Technical Report)},
  author={Michael E. Wieser},
  journal={Pure and Applied Chemistry},
  year={2006},
  volume={78},
  pages={2051 - 2066}
}
  • M. Wieser
  • Published 2006
  • Chemistry
  • Pure and Applied Chemistry
The latest evaluation of atomic weight determinations and other cognate data has warranted 16 changes for the standard atomic weights of the elements, Ar(E), from those published previously in the 2001 Table of Atomic Weights. The revised standard atomic weights are as follows: Ar(Al) = 26.981 5386(8), Ar(Bi) = 208.980 40(1), Ar(Cs) = 132.905 4519(2), Ar(Co) = 58.933 195(5), Ar(Au) = 196.966 569(4), Ar(La) = 138.905 47(7), Ar(Mn) = 54.938 045(5), Ar(Nd) = 144.242(3), Ar(P) = 30.973 762(2), Ar… 
Atomic weights: not so constant after all
  • W. Brand
  • Physics, Medicine
    Analytical and Bioanalytical Chemistry
  • 2012
TLDR
The IUPAC Commission on Isotopic Abundances and Atomic Weights has changed the way certain atomic weights are reported, replacing the fixed ‘standard atomic weight’ with an atomic weight ‘interval’ for ten predominantly light elements, reflecting the variability of their isotopic composition.
Atomic weights of the elements 2013 (IUPAC Technical Report)
Abstract The biennial review of atomic-weight determinations and other cognate data has resulted in changes for the standard atomic weights of 19 elements. The standard atomic weights of four
2 Methodology of Lithium AnalyticalChemistry and Isotopic Measurements 2 . 1 Historical Perspective
  • 2019
Lithiumwas discovered as an elemental species in 1817 by J.A.Arfvedson and isolated as ametal one year later by Sir H. Davy. The existence of two naturally occurring isotopes of lithium, Li and Li,
Thermodynamic characterization of three polymorphic forms of piracetam.
TLDR
The results of the solution and DSC experiments indicate that the stability hierarchy of Forms I, II, and III piracetam is III > II > I.
Energetics of lead(II), cadmium(II) and zinc(II) complexes with amino acids
The molar heat capacity and the standard (p0 = 0.1 MPa) molar enthalpies of formation of the crystalline of bis(glycinate)lead(II), Pb(gly)2; bis(dl-alaninate)lead(II), Pb(dl-ala)2;
A joint experimental and computational investigation on the thermochemistry of (nitrophenyl)pyrroles
Abstract This paper reports the standard (p° = 0.1 MPa) molar enthalpies of formation, in the gaseous phase, Δ f H m ∘ ( g ) , at T = 298.15 K, of 1-(2-nitrophenyl)pyrrole and of
Calorimetric studies on the phenolic glycoside D(-)-salicin.
TLDR
The enthalpy of reaction of hydrolysis of D(-)-salicin to produce beta-glucose and o-hydroxybenzyl alcohol was found marginally thermoneutral, if the uncertainty interval was considered.
Computational study of lanthanide(III) hydration.
Lanthanide(iii) hydration was studied by utilizing density-functional theory and second-order Møller-Plesset perturbation theory combined with scalar-relativistic 4f-in-core pseudopotentials and
Experimental and computational thermochemical study of the dichloronitrobenzene isomers
Abstract The standard (p° = 0.1 MPa) molar enthalpies of formation of 2,4-, 2,5-, 3,4- and 3,5-dichloronitrobenzene isomers, in the crystalline state, at T = 298.15 K, were derived from the standard
Thermochemical study of the monobromonitrobenzene isomers
Abstract The standard (p° = 0.1 MPa) molar enthalpies of formation, of the 2-, 3-, and 4-monobromonitrobenzene isomers, in the crystalline phase, at T = 298.15 K, were derived from the standard
...
1
2
3
4
5
...

References

SHOWING 1-10 OF 21 REFERENCES
Atomic Weights of the Elements
The biennial review of atomic weight, (B), determinations and other cognate data have resulted in the following changes in recommended values (1983 values in parenthesis): Beryllium 9.012182 ± 3
TABLE OF THE ISOTOPES
This table presents an evaluated set of values for the experimental quantities that characterize the decay of radioactive nuclides . A list of the major references used in this evaluation is given
Compilation of minimum and maximum isotope ratios of selected elements in naturally occurring terrestrial materials and reagents
...................................................... Introduction...................................................................^ Basic Concepts
version with corrections)
  • BIPM. International Vocabulary of Metrology -Basic and General Concepts and Associated Terms (VIM), 3
  • 2008
IUPAC Inorganic Chemistry Division. Development of an isotopic periodic table for the educational community
  • 2007
Atomic weights of the elements 2011 1077 Brought to you by | University of California
  • Earth Planet. Sci. Lett. 247,
  • 2006
The Commission on Isotopic Abundances and Atomic Weights notes the death of two former members of the Commission
  • Wieser . Pure Appl . Chem .
  • 2006
Red Book"). Prepared for publication by
  • IUPAC Recommendations 2005 (the
  • 2005
Geochim. Cosmochim
  • Acta 65,
  • 2001
Geochim. Cosmochim
  • Acta 65,
  • 2001
...
1
2
3
...