A study of drilling performances with minimum quantity of lubricant using fuzzy logic rules

@article{Nandi2009ASO,
  title={A study of drilling performances with minimum quantity of lubricant using fuzzy logic rules},
  author={A. Nandi and J. P. Davim},
  journal={Mechatronics},
  year={2009},
  volume={19},
  pages={218-232}
}
  • A. Nandi, J. P. Davim
  • Published 2009
  • Engineering
  • Mechatronics
    • Abstract Nowadays the increasing interest to perform machining operations is in dry/near-dry environments. The reason includes health and safety of operator, cost, ease of chip recyclability, etc. However one important process, which is difficult to perform in dry, is drilling. Without coolant, drilling leads to excessive thermal distortion and poor tool life. In order to tackle these conflicting requirements, the essentiality of study on machining performances with minimum quantity lubricant… CONTINUE READING
    View via Publisher
    70 Citations
    Highly Influential Citations
    1
    Background Citations
    10
    Methods Citations
    18
    70 Citations
    Citation Type

    Citation Type

    Prediction and analysis of multiple quality characteristics in drilling under minimum quantity lubrication
    • 17
    Consideration of fuzzy components for prediction of machining performance: a review
    • 6
    Fuzzy logic for modeling machining process: a review
    • 73
    Machinability comparison of AISI 4340 and Ti-6Al-4V under cryogenic and hybrid cooling environments: A knowledge engineering approach
    • 16
    • Highly Influenced
    Performance evaluation of aluminium 6063 drilling under the influence of nanofluid minimum quantity lubrication
    • 31
    A rule-based system for trade-off among energy consumption, tool life, and productivity in machining process
    • 24
    FUZZY LOGIC BASED DRILLING CONTROL PROCESS
    • 3
    Concurrent Optimization and an Experimental Analysis of Face Milling Operation Parameters for Optimal Performance on Mild Steel Work Piece
    • 1
    Fuzzy logic based model for predicting surface roughness of machined Al–Si–Cu–Fe die casting alloy using different additives-turning
    • 61
    • PDF
    Evaluation of tool temperature distribution in MQL drilling of aluminum 2024-T351

    References

    SHOWING 1-10 OF 35 REFERENCES
    TSK-type FLC using a combined LR and GA: Surface roughness prediction in ultraprecision turning
    • 17
    MINIMUM QUANTITY LUBRICATION (MQL) APPLICATIONS IN AUTOMOTIVE POWER-TRAIN MACHINING
    • 61
    Experimental analysis and optimisation of tool wear in dry machining of aluminium alloys
    • 215
    Using a minimum quantity of lubricant (MQL) and a diamond coated tool in the drilling of aluminum–silicon alloys
    • 231
    The performance of cutting fluids when machining aluminium alloys
    • 30
    Automatic design of fuzzy logic controller using a genetic algorithm—to predict power requirement and surface finish in grinding
    • 34
    Analysis of temperature during drilling of Ti6Al4V with minimal quantity of lubricant
    • 137
    Investigations on hard coated reamers in different lubricant free cutting operations
    • 48
    New hard/lubricant coating for dry machining
    • 192
    Effects of cryogenic cooling by liquid nitrogen jets on tool wear, surface finish and dimensional deviation in turning different steels
    • 13