A revisit of the electro-diffusional theory for the wall shear stress measurement

@article{Havlica2021ARO,
  title={A revisit of the electro-diffusional theory for the wall shear stress measurement},
  author={Jaromir Havlica and David Kramoli{\vs} and Florian Huchet},
  journal={International Journal of Heat and Mass Transfer},
  year={2021}
}
1 Citations

Figures from this paper

Application of the diagnostic plot in estimation of the skin friction in turbulent boundary layer under an adverse pressure gradient

The paper concerns the problem of determining friction velocity in wallbounded flows affected by an adverse pressure gradient (APG). In the work of Niegodajew et al. [22] the corrected Clauser chart

References

SHOWING 1-10 OF 40 REFERENCES

Electrodiffusion detection of the near-wall flow reversal in liquid films at the regime of solitary waves

The liquid film flow down an oscillating plate was used as a suitable flow configuration to study the dynamic behaviour of electrodiffusion friction probes at large fluctuations. The two-segment

A study of turbulence at a wall using an electrochemical wall shear-stress meter

A technique has been developed to measure the instantaneous shear stress at the boundary over which a liquid is flowing. It is being used to study turbulence in the immediate vicinity of a pipe wall.

An experimental study of the unsteady nature of the viscous sublayer

Measurements of the fluctuations in the mass transfer rate to small circular electrodes mounted flush with a pipe wall are used to study the unsteady nature of the viscous sublayer. These

Heat/mass transfer from surface films to shear flows at arbitrary Peclet numbers

An efficient numerical method is described for studying the combined conductive and convective transport from a surface film on a planar boundary to a fluid in simple shear flow. Such problems arise

On the measurement of wall shear stress

The differential pressure reading from a static hole pair is utilized for determination of the local wall shear stress. Both the hole diameter and forward-facing angle are varied to test the

Application of an inverse mass transfer method to the measurement of turbulent fluctuations in the velocity gradient at the wall

The frequency response of the concentration boundarylayer is often a concern when flush mounted mass transfer probes are used to measure turbulent fluctuations in the velocity gradient at a wall.

Unsteady flows in milli- and microsystems: analysis of wall shear rate fluctuations

The particular benefits of microfluidic systems, in terms of heat and mass transfer enhancement, require conducting local flow diagnostics, especially when unsteady properties of the microflow can