A case study about acquisition of mechanically fixed cutting inserts

@inproceedings{Daicu2017ACS,
  title={A case study about acquisition of mechanically fixed cutting inserts},
  author={Raluca Daicu and Valentin Dițu and Gheorghe Oancea},
  year={2017}
}
During the process of turning metals there are used cutting inserts that can be acquisitioned from different producers. Because the offer is varied the acquisition must be made after an economical analysis that includes experimental tries. The paper presents an acquisition methodology for metallic carbide cutting inserts and presents a case study. This research was developed using three batches of cutting inserts acquisitioned from different producers. The specimen material was 1C45 and using… Expand
1 Citations

Figures and Tables from this paper

The optimization of cutting parameters at turning, using electrical current at cutting, in order to increase the durability of the cutting tool
TLDR
The paper proposes the analysis of the electrical current at cutting and its use for optimization and the processing of the experimental data obtained as well as the optimization of the cutting parameters was performed using Design Expert software. Expand

References

SHOWING 1-5 OF 5 REFERENCES
Innovative approach of drills acquisition using electrical current. A case study
During the process of drilling metals there are used cutting tools that can be acquisitioned directly from the producers, from distributors or from supermarkets. Because the offer is varied and thereExpand
Researches on evaluation of smooth entrance in cutting using electrical current. A case study
At metal drilling, at the beginning of the process, the cutting tool in the chisel edge zone, frictions and plastically deforms the material, and then enters in cutting. If the drill is enteredExpand
Selection of cemented carbide turning tools using EMF and optimization criteria
Abstract Tool life and quality of surface finish of the workpiece influence production rate and production cost. Cemented carbide tools have found wide application in the production arena ofExpand
Electrical Current at Metal Cutting Process: A Literature Review
Processing metallic materials by cutting using good electricity conductor cutting edges it appears an electrical current due mainly to the temperature in the cutting zone. Analyzing of the electricalExpand
Thermoelectric wear in tools
Abstract Thermoelectric tool wear was measured by the thermocurrent generated in Machine-Tool-Workpiece-Machine (MTWM) circuit. The relationship between thermocurrent and the cutting parameters inExpand