A 30kV/24A Hard-Tube Pulser for Electron Guns and Microwave Generators

@article{Rossi2005A3H,
  title={A 30kV/24A Hard-Tube Pulser for Electron Guns and Microwave Generators},
  author={J. O. Rossi and J. J. Barroso and D. S. Ricotta and M{\'a}rio Ueda},
  journal={2005 IEEE Pulsed Power Conference},
  year={2005},
  pages={1089-1092}
}
Currently under development in our laboratory, a microwave generator (monotron) at 6.7 GHz will operate with a beam current of 16 A at 10 kV. For this, normally we employ an on-off power modulator that uses only a floating high voltage switch to discharge a capacitor through the device. However because of the high voltage isolation between the tube deck and control panel at the ground and the relatively low current of the tube cathode (10 A), we are proposing a new pulser design. In this… CONTINUE READING
2 Citations
1 References
Similar Papers

Citations

Publications citing this paper.
Showing 1-2 of 2 extracted citations

References

Publications referenced by this paper.

A lOOkV/1OA high voltage pulse the DC power supply to positive polarity as required by generator for plasma immersion ion implantation

  • J. J. Barroso, J. O. Rossi et al., +5 authors we converted the negative polarity of J. Brutcher
  • Rev. the new circuit scheme of Fig. 2. According…
  • 1996
1 Excerpt

Similar Papers

Loading similar papers…