• Publications
  • Influence
Low-cycle fatigue behavior of Sn-Ag, Sn-Ag-Cu, and Sn-Ag-Cu-Bi lead-free solders
Low-cycle fatigue (LCF) tests on as-cast Sn-3.5Ag, Sn-3Ag-0.5Cu, Sn-3Ag-0.5Cu-1Bi, and Sn-3Ag-0.5Cu-3Bi solders was carried out using a noncontact strain-controlled system at 20°C with a constantExpand
  • 107
  • 4
Low cycle fatigue behavior and mechanisms of a eutectic Sn-Pb solder 63Sn/37Pb
Abstract Low cycle fatigue tests of as-casted Sn–Pb eutectic solder (63Sn/37Pb) were carried out using the non-contact strain controlled system at 20°C. The fatigue behavior followed theExpand
  • 81
  • 3
Microstructure and mechanical properties of magnesium composites prepared by spark plasma sintering technology
Abstract Spark plasma sintering (SPS) technology was used to determine the appropriate conditions for SPS sintering of commercially pure magnesium as well as the magnesium alloy AZ31. It was foundExpand
  • 65
  • 3
Low-cycle fatigue behavior and mechanisms of a lead-free solder 96.5Sn/3.5Ag
Low-cycle fatigue tests of as-cast Sn-Ag eutectic solder (96.5Sn/3.5Ag) were performed using a noncontact strain controlled system at 20°C. The fatigue behavior followed the Coffin-Manson equationExpand
  • 70
  • 2
Suppression of intermetallic reaction layer formation by controlling heat flow in dissimilar joining of steel and aluminum alloy
In order to suppress the formation of intermetallic reaction layer during laser welding of steel and aluminum alloy dissimilar materials, effect of backing block (heat sink) was investigated. FEMExpand
  • 138
  • 2
In situ observation of fatigue crack retardation in banded ferrite–pearlite microstructure due to crack branching
This paper reports the results of in situ observation of fatigue crack growth in a ferrite–pearlite steel. Stress intensity factor range (ΔK) decreasing/increasing and constant-ΔK fatigue tests haveExpand
  • 72
  • 2
Utilising friction spot joining for dissimilar joint between aluminium alloy (A5052) and polyethylene terephthalate
Abstract The weld strength of thermoplastics with aluminium alloy, such as high density polyethylene and polypropylene sheets, is influenced by friction stir welding parameters. This paper focuses onExpand
  • 64
  • 2
Application of friction stir welding for several plastic materials
Application of friction stir welding (FSW) known as a low heat input process to plastic materials was studied. Several plastic materials such as high density polyethylene (HDPE), polyamide 6 (PA6)Expand
  • 20
  • 2
Fatigue Life Prediction of Magnesium Alloys for Structural Applications
There has been growing interest in studies on fatigue strength and fatigue crack growth behavior of magnesium alloys. In the present study, fatigue-life prediction of magnesium alloys based on aExpand
  • 35
  • 2
Fatigue crack growth behavior of 96.5Sn–3.5Ag lead-free solder
Abstract The fatigue crack growth tests of 96.5Sn–3.5Ag solder have been carried out at frequencies from 0.1 to 10 Hz and at stress ratios from 0.1 to 0.7. Fatigue cracks propagated in aExpand
  • 61
  • 1
...
1
2
3
4
5
...