Author pages are created from data sourced from our academic publisher partnerships and public sources.
Share This Author
On the mechanism of residual stresses relaxation in welded joints under cyclic loading
Mixed mode fatigue crack growth behavior of Ni-Cr-Mo-V high strength steel weldments
Effect of strain hardening and strain softening on welding distortion and residual stress of A7N01-T4 aluminum alloy by simulation analysis
The effect of strain hardening and strain softening behavior of flow stress changing with temperature on welding residual stress, plastic strain and welding distortion of A7N01-T4 aluminum alloy was…
Welding deformation controlling of aluminum-alloy thin plate by two-direction pre-stress method
Influence of a welding sequence on the welding residual stress of a thick plate
The residual stress in one-groove welding using an ellipsoidal heat source is analysed. The results show that it can ameliorate the residual stress distribution and greatly decrease the peak value of…
Cavitation at filler metal/substrate interface during ultrasonic-assisted soldering. Part I: Cavitation characteristics.
Cavitation at filler metal/substrate interface during ultrasonic-assisted soldering. Part II: Cavitation erosion effect.
Low-Cycle Fatigue Behavior of 10CrNi3MoV High Strength Steel and Its Undermatched Welds
Strain, plastic and total strain energy density amplitudes against the number of reversals to failure results demonstrate that the undermatched weld metal presents a higher resistance to fatigue crack initiation than 10CrNi3MoV high strength steel.
Effect of Sheet Configuration on Microstructure and Mechanical Behaviors of Dissimilar Al–Mg–Si/Al–Zn–Mg Aluminum Alloys Friction Stir Welding Joints