Learn More
—We present for the first time, a fully integrated battery powered RFID integrated circuit (IC) for operation at ultra-high frequency (UHF) and microwave bands. The battery powered RFID IC can also work as a passive RFID tag without a battery or when the battery has died (i.e., voltage has dropped below 1.3 V); this novel dual passive and battery operation(More)
PURPOSE The primary objective of this prospective cohort study was to evaluate primary and secondary implant stability values of implants placed into healed free fibula-reconstructed mandibles. The secondary objective was to investigate whether a correlation existed between primary implant stability and the quantity of cortical bone-implant contact and of(More)
CONTEXT Fine-needle aspiration cytology is the first step in evaluation of thyroid nodules. Although the Bethesda classification for reporting thyroid cytology has been purported that this uniformity in reporting cytology thereby facilitating clinical decision-making, there are also studies indicating that the reporting percentage and the rates of(More)
Tumors arising from the posterior hard palate or posterolateral maxilla may extend to involve the infratemporal fossa (ITF). Resection of these tumors results in infrastructural maxillectomy with ITF defects. In this study, we describe the use of an adipofascial anterolateral thigh flap (ALT) specifically for such defects. This case series includes four(More)
A stacked antenna front-end for RFIDs is presented. Schottky diode based voltage doubler charge pumps are used on the front-end. The use of schottky diodes permits broadband operation for UHF (915MHz) as well as Microwave (2.45GHz). The entire chip has a low power EEPROM, digital state machine, clock recovery and data demodulation circuits; and the chip(More)
INTRODUCTION Facial contour deformities presents with varied aetiology and degrees severity. Accurate assessment, selecting a suitable tissue and sculpturing it to fill the defect is challenging and largely subjective. Objective assessment with imaging and software is not always feasible and preparing a template is complicated. A three-dimensional (3D) wax(More)
  • 1