• Publications
  • Influence
A Low-Voltage PLL With a Supply-Noise Compensated Feedforward Ring VCO
TLDR
A low-voltage phase-locked-loop (PLL) circuit with a supply-noise-compensated feedforward ring voltage-controlled oscillator. Expand
  • 13
  • 1
  • PDF
A 32-Gb/s PAM-4 Quarter-Rate Clock and Data Recovery Circuit With an Input Slew-Rate Tolerant Selective Transition Detector
TLDR
We present a 32-Gb/s PAM-4 quarter-rate clock and data recovery (CDR) circuit having a newly proposed selective transition detector (STD). Expand
  • 4
  • 1
Fabrication of a biodegradable drug delivery system with controlled release made of PLGA/5‐FU/hydroxyapatite
Purpose – Rapid prototyping (RP) technology has been widely applied in biomedical research. The purpose of this paper is to describe how a scaffold composite drug delivery system (DDS) was fabricatedExpand
  • 12
Integration of dual channel timing formatter system for high speed memory test equipment
  • J. Park, Ingeol Lee, +9 authors S. Kang
  • Engineering, Computer Science
  • International SoC Design Conference (ISOCC)
  • 1 November 2012
TLDR
This paper proposes a dual channel timing formatter system for high speed memory test equipment with 20ps timing resolution. Expand
  • 13
  • PDF
A 990-$\mu\hbox{W}$ 1.6-GHz PLL Based on a Novel Supply-Regulated Active-Loop-Filter VCO
TLDR
A low-power 1.6GHz phase-locked loop (PLL) based on a novel supply-regulated voltage-controlled oscillator (SR-VCO) including an active-loop filter (ALF) is realized. Expand
  • 12
  • PDF
A 5–8 Gb/s low-power transmitter with 2-tap pre-emphasis based on toggling serialization
TLDR
We demonstrate a low-power wireline transmitter with 2-tap pre-emphasis in which serialization is achieved by toggling serializer with data transition information extracted from parallel input data. Expand
  • 5
  • PDF
A 0.4-V, 500-MHz, ultra-low-power phase-locked loop for near-threshold voltage operation
TLDR
We present a 500-MHz, ultra-low-power phase-locked loop (PLL) realized with the near-threshold supply voltage of 0.4 V in 65-nm CMOS technology. Expand
  • 5
Fabrication of micro parts using nano composite deposition system
Purpose – The purpose of this research, is to develop a nano composite deposition system (NCDS) to fabricate three dimensional functional nano composite parts.Design/methodology/approach – The NCDSExpand
  • 17
A Comparative Study for the Fatigue Assessment of Side Shell Longitudinals on 8,100 TEU Container Carrier using Hot Spot Stress and Structural Stress Approaches
AbstractRecently, a mesh-size insensitive structural stress definition (structural stress method) is proposed that gives a stress state at weld toe with a relativel y large mesh size. The structuralExpand
  • 3
...
1
2
...