• Publications
  • Influence
3D printed microfluidic devices: enablers and barriers.
3D printing has the potential to significantly change the field of microfluidics. The ability to fabricate a complete microfluidic device in a single step from a computer model has obviousExpand
  • 434
  • 7
Cost-effective three-dimensional printing of visibly transparent microchips within minutes.
One-step fabrication of transparent three-dimensional (3D) microfluidic to millifluidic devices was demonstrated using a commercial 3D printer costing $2300 with 500 mL of clear resin for $138. ItExpand
  • 295
  • 7
Comparing Microfluidic Performance of Three-Dimensional (3D) Printing Platforms.
Three-dimensional (3D) printing has emerged as a potential revolutionary technology for the fabrication of microfluidic devices. A direct experimental comparison of the three 3D printing technologiesExpand
  • 129
  • 3
  • PDF
Identification of inorganic improvised explosive devices by analysis of postblast residues using portable capillary electrophoresis instrumentation and indirect photometric detection with a
A commercial portable capillary electrophoresis (CE) instrument has been used to separate inorganic anions and cations found in postblast residues from improvised explosive devices (IEDs) of the typeExpand
  • 119
  • 2
  • PDF
Identification of homemade inorganic explosives by ion chromatographic analysis of post-blast residues.
Anions and cations of interest for the post-blast identification of homemade inorganic explosives were separated and detected by ion chromatographic (IC) methods. The ionic analytes used forExpand
  • 83
  • 2
Conductivity detection for conventional and miniaturised capillary electrophoresis systems
Since the introduction of capillary electrophoresis (CE), conductivity detection has been an attractive means of detection. No additional chemical properties are required for detection, and no lossExpand
  • 121
  • 1
One-Step Fabrication of a Microfluidic Device with an Integrated Membrane and Embedded Reagents by Multimaterial 3D Printing.
One of the largest impediments in the development of microfluidic-based smart sensing systems is the manufacturability of integrated, complex devices. Here we propose multimaterial 3D printing forExpand
  • 55
  • 1
Identification of inorganic ions in post‐blast explosive residues using portable CE instrumentation and capacitively coupled contactless conductivity detection
Novel CE methods have been developed on portable instrumentation adapted to accommodate a capacitively coupled contactless conductivity detector for the separation and sensitive detection ofExpand
  • 83
  • 1
Counter-flow electrokinetic supercharging for the determination of non-steroidal anti-inflammatory drugs in water samples.
Electrokinetic supercharging (EKS) has been used in the last few years as a powerful tool for separation and on-line preconcentration of different types of analytes. We have developed a valuableExpand
  • 39
  • 1
Determination of inorganic ions using microfluidic devices
The separation and detection of inorganic ions on microfluidic devices has received little attention since the ‘lab‐on‐a‐chip’ concept has revolutionised the field of electrokinetically drivenExpand
  • 42
  • 1